ZEPIA EnergyApS SW-150 Instruction Manual

Technical data:
SW-100-12V SW-150-12V
Input voltage (dc) 12V
Input voltage range 11-15V 11-15V
Max. input current 10A
Battery low - warning 12V
Battery low - switch off 10,5V
Battery recharged - switch on 12,5V
Stand-by consumption 2,5VA
DC fuse protection 1 x 15A 1 x 20A
Continuous output power 100VA
Peak output power 200VA
Output voltage (ac) 225V
Frequency (+/-1%) 50 Hz
Max. output current 0,45/0,9 A 0,7/1,5 A
eff
(continuous/peak)
Efficiency above 88% above 88%
Input type cigarette lighter cigarette lighter
Output power outlet 1 × EURO 1 × Schuko
Fan cooling no
Can be operated by remote no
control
Dimensions (mm) 170×50 120x245x70
Weight 0,5 kg
"E" Mark reg. number
SW-600-12V SW-600-24V
Input voltage (dc) 12V 24V
Input voltage range 11-15V 22-30V
Max. input current 70A 35A
Battery low - warning 12V 23V
Battery low - switch off 10,5V 21V
Battery recharged - switch on 12,5V 25V
Stand-by consumption 4,2VA 6VA
DC fuse protection 2 × 40A 2 × 20A
Continuous output power 600VA 600VA
Peak output power 1200VA 1200VA
Output voltage (ac) 225V 225V
Frequency (+/-1%) 50 Hz 50 Hz
Max. output current 2,8/5,6 A 2,8/5,6 A
eff
(continuous/peak)
Efficiency above 88% above 88%
Input type pole terminal pole terminal
Output power outlet 1 × Schuko 1 × Schuko
1 × Euro 1 × Euro
Fan cooling yes yes
Can be operated by remote yes yes
control
Dimensions (mm) 340x245x70 340x245x70
Weight 3,5 kg 3,5kg
"E" Mark reg. number
Recommended minimum DC wire cross section for SW300, 600, 1200, 2000 models:
up to 2m up to 3m
SW-300 16mm² 16mm²
SW-600 16mm² 16mm²
SW-1200 25mm² 35mm²
SW-2000 35mm² 50mm²
Subject to alteration
ZEPIA Energy ApS, Demetervej 13, 9210 Aalborg SØ, Denmark
Phone: +45 9631 0199, e-mail: info@zepiaenergy.dk; URL:
SW-150-24V SW-300-12V
12V 24V 12V
22-30V 11-15V
18A 9A 35A
12V 23V 12V
10,5V 21V 10,5V
12,5V 25V 12,5V
2,4VA 3,6VA 3,6VA
1 × 15A 1 × 40A
150VA 150VA 300VA
300VA 300VA 600VA
225V 225V 225V
50 Hz 50 Hz 50 Hz
0,7/1,5 A 1,4/3 A
eff eff eff
above 88% above 88%
cigarette lighter pole terminal
1 × Schuko 1 × Schuko
1 × Euro
no no no
no no yes
120x245x70 240x245x70
1,3 kg 1,3 kg 2,7 kg
e1 024372
SW-1200- SW-1200- SW-2000-
12V 24V 12V
12V 24V 12V
11-15V 22-30V 11-15V
140A 70A 220A
12V 23V 12V
10,5V 21V 10,5V
12,5V 25V 12,5V
10,8VA 12VA 18VA
4 x 40A 4 x 20A 6 x 40A
1200VA 1200VA 2000VA
1800VA 1800VA 3000VA
225V 225V 225V
50 Hz 50 Hz 50 Hz
5,6/11,2 A 5,6/11,2 A 9,3/18,6 A
eff eff eff eff
above 88% above 88% above 88%
pole terminal pole terminal pole terminal
1 × Schuko 1 × Schuko 1 × Schuko
1 × Euro 1 × Euro 1 × Euro
yes Yes yes
yes yes yes
390x245x70 390x245x70 455x245x70
4,5 kg 4,5 kg 5,2 kg
e1 024372
http://www.zepiaenergy.dk
ZEPIA EnergyApS
SW-300-24V
24V
22-30V
18A
23V
21V
Dear Customer,
25V
4,8VA
1 × 20A
Thank you for buying our product. You have bought one of the most powerful, most compact and most reliable
300VA
sine wave inverter of its class. Please make sure to read this manual carefully before putting the unit into
600VA
operation.
225V
50 Hz
1,4/3 A
eff
WARNING!!! Important security advice!
- Warning!! Use fluorescent lamps only with electronic starters or with an electronic transformer. Using
above 88%
fluorescent lamps with normal starters will damage your inverter.
pole terminal
1 × Schuko
- This unit produces alternating current of 230V and is not to be put in children's hands!
1 × Euro
- Even when the unit has been turned off, there can still be 230V AC at the output for a while.
no
- Must not be operated under adverse circumstances such as: Temperatures above 50°C, inflammable gas,
yes
solvents, vapours, dust, and humidity over 80 % rel. or water.
240x245x70
- The unit must only be operated in closed, dry rooms.
2,7 kg
- Important for SW-100 models: Only devises with protection class II. (
must be connected. These devises are normally equipped with a Euro-plug. Services with protection class
SW-2000-
I. (
24V
- Important for SW-150, 300, 600, 1200, 2000 models: All alternating current loads, which belong to
24V
Protection Class I. (units with 3-pinned plug containing Earth-pin) must be earthed via the PE-connector
22-30V
at the inverter's output socket. According to regulations the PE-connector of the output socket, the
110A
23V
inverter housing and the minus pole of the battery are all internally connected. The separate earth screw
21V
must be grounded for the SW-150.
25V
- - None of the two inverter output (no Line or Neutral wire!) can be connected in any way to the Ground.
21,6VA
- As soon as you assume that operation of the unit under safe circumstances is no longer possible, unplug
6 x 20A
2000VA
the unit immediately and make sure that it not put into operation inadvertently. Operating the unit
3000VA
becomes unsafe when the unit does not show any signs of working or has been visibly damaged (e.g.
225V
damage has occurred during transport or after storing the unit under unfavourable circumstances).
50 Hz
- Service and repairs - Servicing and repairs must be conducted by authorised personnel only. Only fuses of
9,3/18,6 A
eff
the indicated value shall be used as replacement. It is not allowed to use repaired fuses or short-circuit the
above 88%
fuse holders.
pole terminal
- Important for SW-300, 600, 1200, 2000 models: To achieve proper electrical contact between the bolts
1 × Schuko
1 × Euro and the battery cables, always fasten the nuts of the DC connectors (figure 1) even if only used for testing
yes
purposes.
yes
Servicing and repair
455x245x70
5,2 kg can be conducted by authorised personnel only. Only fuses with the same rating and characteristics can be used
as replacement. It is forbidden to mend the burned fuse or short-circuit the fuse-holder. Before service or fuse
replacement, all equipment must be disconnected from the inverter and the inverter itself from the batteries. It is
necessary to wait for an additional 3 minutes in order to avoid electric shock hazard from the internal
capacitors.
Description
Inverters of the SW family are modern, microprocessor-controlled devices especially suited for mobile
applications. The inverter converts the low DC input voltage into a higher AC voltage. The output signal
voltage corresponds to a true sinusoidal alternating voltage. Unlike trapezoidal inverters, true sine wave
inverters will provide a largely trouble-free operation to highly sensitive measuring equipment, computer
systems, audio and DVD equipment, satellite systems, television sets, pumps and all devices with a transformer.
September 2009

INSTRUCTION MANUAL

SW SINEWAVE INVERTERS
SW-100 SW-150 SW-300 SW-600 SW-1200 SW-2000
with ground/earth connector) can cause danger to life.
no ground/earth connector)