Download Print this page

LOCKEY 2900 Installation Instructions And Template

2900 series

Advertisement

Quick Links

The Lockey 2900 Series is designed for narrow stile prep doors or for configurations with existing
narrow stile hardware with 1 1/8" prep.
NOTE: For 1 1/8" narrow stile prep doors, please skip to Step 2
1.) Remove all previously installed hardware.
NOTE: Do NOT discard previously installed Trim Plate (may be used)
2.) Using the Template provided, mark mounting holes on the surface of the door.
NOTE: After marking mounting holes, check to ensure the spindle hole is placed at the
bottom. This is a reverse mounting as compared to most all Adams Rite configurations.
3.) Check templating to guarantee proper measurements and hole pattern.
4.) Drill holes accordingly.
5.) After drilling mounting holes, check to make sure that the lock and tailpiece line up with holes
correctly.
YOU ARE NOW READY TO INSTALL YOUR LOCKEY 2900 SERIES LATCH OR BOLT
6.) Secure top and bottom mounting screws on latch/bolt.
7.) Place rubber escutcheon on outside body and place outside body on door.
NOTE: In some cases, the rubber escutcheon may need to be trimmed on the inside body so that the
jamb side does not have a lip on it. This is due to the jamb edge on the interior of the door. In rare
cases, you may also need to trim the jamb edge to accommodate the lock.
8.) Hold outside body of the lock to the door, placing tailpiece through latch/bolt spindle hole.
Check to ensure that the tailpiece engages the lock.
9.) Place and secure inside body on the door using the provided screws.
After installing lock, replace and secure face plate. Please Note: Due to variances in face plate sizes,
you may need to use previously installed face plate, depending on previous configuration.
NOTE: Due to reverse positioning of the Lockey 2900, 2930, 2935, and 2985, the strike may need to
be modified to accommodate latch/bolt. For latches, you must ensure that the deadlocking plunger
above the latch is pressed in when door is closed. If the plunger is not pressed in, the latch will not
deadlock, compromising security.
Lockey® 2900 Series
2900 | 2950 | 2930 | 2945 | 2985
Installation Instructions & Template

Advertisement

loading

Summary of Contents for LOCKEY 2900

  • Page 1 NOTE: Due to reverse positioning of the Lockey 2900, 2930, 2935, and 2985, the strike may need to be modified to accommodate latch/bolt. For latches, you must ensure that the deadlocking plunger above the latch is pressed in when door is closed.
  • Page 2 Lockey® 2900 Series 2900 | 2950 | 2930 | 2945 | 2985 Installation Instructions & Template HANDING INSTRUCTIONS (2930, 2945, 2985) IMPORTANT: DO NOT REMOVE CAM FROM LATCH WHEN CHANGING HANDING Change Latch Handing 1. Remove screws from both sides of latch casing.
  • Page 3 Lockey® 2900 Series 2900 | 2950 | 2930 | 2945 | 2985 Installation Instructions & Template 2985 2945 2930 Lockey 1 1/8” Latch Template 1” 3/8” 9/16” 3/8” 1/4” 1 3/4” Door...
  • Page 4 Lockey® 2900 Series 2900 | 2950 | 2930 | 2945 | 2985 Installation Instructions & Template 2900 2950 Lockey & 1 1/8” Bolt Template 3/8” 3/8” 9/16” 3/8” 1/4” 1 3/4” Door...

This manual is also suitable for:

2950294529852930