NexxTech 4313388 Owner's Manual

OWNERʼS MANUAL —
Please read before using this equipment.
1
2
3
4
5
6
7
8
9

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and injury to
persons, including the following:
1. Do not use this product near water, for example, near a bath tub,
wash bowl, kitchen sink or laundry tub, in a wet basement or near a
swimming pool.
2. Avoid using a telephone (other than a cordless type) during an
electrical storm. There may be a remote risk of electric shock from
lightning.
3. Do not use the telephone to report a gas leak in the vicinity of the
leak.
4. Use only the power cord and batteries indicated in this manual. Do
not dispose of batteries in a fire. They may explode. Check with local
codes for possible special disposal instructions.
SAVE THESE INSTRUCTIONS!
INDUSTRY CANADA CS03 STATEMENT
This product meets the applicable Industr y Canada technical
specifications. This is confirmed by the registration number. The
abbreviation, IC before the registration number signifies that registration
was performed based on a Declaration of Conformity indicating that
Industry Canada technical specifications were met. It does not imply that
Industry Canada approved the equipment.
Before installing this equipment, users should ensure that it is permissible
to be connected to the facilities of the local telecommunications company.
The equipment must also be installed using an acceptable method of
connections. The customer should be aware that compliance with the
above conditions may not prevent degradation of service in some
situations. Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any repairs or
alterations made by the user of this equipment, or equipment malfunctions,
may give the telecommunications company cause to request the user to
disconnect the equipment.
WARNING! Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection authority,
or an electrician, as appropriate.
CAUTION: The Ringer Equivalence Number (REN) assigned to each
terminal device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination on an
interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5. An alternative indication of the REN is the
TM
MC
CALL #
NEW
1. Receiver
10 2. Receiver Volume Control
3. Hook Switch
11
4. Key Pad
5. Tone/Pulse Switch
12
6. Redial Button
13
7. Transmitter
14
8. Store Button
15
9. Mem Button
16
* Caller ID Telephone
*Requires subscription to additional features
provided by your local telephone service provider.
Load Number (LN); this number should be divided by 20 to approximate
the equivalent REN. The REN Number of this unit is indicated on the
bottom of your answering machine.

BATTERY NOTES

Dispose of old battery promptly and properly.
Do not burn or bury batteries.
Use only fresh batteries of the required size and recommended type.
Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different capacities.
If you do not plan to use the phone for two weeks or longer, remove the
batteries. Batteries can leak chemicals that can destroy electronic parts.
You must install the batteries before connecting the telephone to the wall
jack. If no batteries are installed, the telephone and Caller ID will not
work.
If you do not replace the batteries within two minutes, your Caller ID and
telephone memory information may be lost.
CALLER ID TELEPHONE
4313388/4313389
10. New Call LED
11. Ringer Hi/Lo/Off Switch
12. LCD Display
13. Battery Compartment
14. Review
15. Erase Button
16. Call Back Button
Button
/