Download Print this page

Radio Shack 49-2515 Owner's Manual

1/3-inch b&w indoor/outdoor camera

Advertisement

Quick Links

www.radioshack.com
OWNER'S MANUAL —
Please read before using this equipment.
Thank you for purchasing a RadioShack
Inch B&W Indoor/Outdoor Camera. Your
camera is super-small and compact. It is
designed for use with a RadioShack 10-Inch
B&W Single Channel Security Monitor (Cat.
No. 49-2514) to provide a safe and secure
environment.
%#/'4#"/1706+0)")7+&'.+0'5
Carefully plan where and how you will
position the camera and where you will route
the cable that connects the camera to the
monitor. When planning the installation:
• Select a location for the camera that
provides a clear view of the area you
want to monitor, is free from dust, and is
not in direct sunlight or in line-of-sight of
a strong light source .
/1706+0)"#0&"+056#..+0)"6*'"%#/'4#
You can mount the camera indoors or
outdoors in a permanent location such as a
wall or on a movable platform (such as a
tripod) for mounting on a desk, shelf, or table.
1. Use the base of the camera as a guide,
mark the locations for the screw holes on
the mounting surface.
2. Drill a starter hole at each marked
location. If necessary, drill a third hole (at
least 14 mm in diameter) below the
mounting holes to permit the camera's
cable to be inserted through the
mounting surface.
3. If necessary, insert the supplied drywall
anchors into the screw holes.
4. Insert one of the two supplied screws
through each of the screw holes in the
bracket and into the mounting surface,
then tighten each screw until the base is
secure.
5. Loosen the screw from the camera's
arm-sleeve and fully insert the base's
arm into the sleeve. Then secure the
If an icon appears at the end of a paragraph, go to the box on that page with the corresponding icon for
pertinent information.
R R R R ý
#
— Warning
— Important
1
/
Built-in Speaker and Microphone — allow
-
3
2-way communication with compatible
equipment.
CMOS (Complementary Metal-Oxide
Semiconductor) Sensor — provides
superior-resolution B&W images.
• Do not install the camera in a location
Though the camera is highly sensitive, it cannot
"see" over a wide area in total darkness. To
assist the camera's night vision, install a 100-
watt incandescent lamp (rich in infrared
radiation) to illuminate the camera's viewing
area. You can also use a small incandescent
flood lamp. Halogen lamps, other high pressure
outdoor lamps, and fluorescent lighting are
infrared-poor and not recommended.
where it will be exposed to high humidity
or rain.
arm and sleeve together by tightening
the screw.
5'66+0)"72"6*'"
%#/'4#
%
100'%6+0)
/
10+614
1. Connect the camera's mini-DIN plug into
the supplied 59-foot cable's mini-DIN
socket.
#
#
"+/2146#06"
± ± ± ±
— Note
1
/
+PEJ"$(9"+PFQQT11WVFQQT"%COGTC
3
5
±
±
"016'"
"
"&
"
"
+4'%6.;
61
6*'
° ° ° °
. . . .
— Caution
— Hint
Passive Infrared (PIR) Sensor — detects
motion up to 16.5 feet away from an angle of
up to 100°.
Weatherproof — so you can mount the
camera indoors or outdoors.
• Plan the cable's route so it is not close to
power or telephone lines, transformers,
microwave ovens, or other electrical
equipment that could interfere with (or
accept interference from) the system.
• Select a location for the camera that has
an ambient temperature between –4 F
(–20 C) and 122 F (50 C).
• If you plan to install the camera in a
location that has conditions not
recommended in this manual, consult
with a professional installer and consider
use of a separate camera cover or
housing.
2. Connect the 59-foot cable to the
monitor's mini-DIN port.
WARNING:
To reduce the risk of fire or
shock hazard, do not expose this product to
rain or moisture.
CAUTION
"
RISK OF ELECTRIC
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE COV-
ER OR BACK. NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED PERSONNEL.
The lightning symbol is intended to
alert you to the presence of uninsu-
lated dangerous voltage within this
product's enclosure that might be of
sufficient magnitude to constitute a
risk of electric shock. Do not open
the product's case.
The exclamation symbol is intended
to inform you that important operat-
!
ing and maintenance instructions
are included in the literature accom-
panying this product.
©
2002 RadioShack Corporation.
All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
49-2515
!
SHOCK

Advertisement

loading

Summary of Contents for Radio Shack 49-2515

  • Page 1 2002 RadioShack Corporation. All Rights Reserved. RadioShack and RadioShack.com are trademarks used by RadioShack Corporation. ° ° ° ° — Hint 49-2515 To reduce the risk of fire or CAUTION SHOCK DO NOT OPEN TO REDUCE THE RISK OF lated dangerous voltage within this risk of electric shock.
  • Page 2 "#18"+ " " "5 5+0) 02765 9+6%*$1: 1. Connect the extension cable’s mini-DIN plug into the supplied 6-inch adapter cable’s mini-DIN socket. 2. Connect the adapter cable’s yellow end to your TV’s video jack, and connect the white end to your TV’s audio jack. 3.

This manual is also suitable for:

Dmb-1812lDmb-1812lh