Advertisement
Quick Links
HERSHEY'S
®
Classic Syrup
Dispenser
COMPLETE UNIT 87952
MODEL: SPPH
PUMP ONLY 88548
MODEL: BP-1
Used with Hershey's
64 oz pouches
with 16mm fitments.
Thank You
...for purchasing this dispenser.
The reliable, reusable pump lasts for years
while the environmentally friendly pouch system
minimizes landfill impact.
CONSISTENT PORTIONS—SERVE BETTER
Advertisement
Related Manuals for Hershey's Serve Better SPPH
Summary of Contents for Hershey's Serve Better SPPH
- Page 1 HERSHEY’S ® Classic Syrup Dispenser COMPLETE UNIT 87952 MODEL: SPPH PUMP ONLY 88548 MODEL: BP-1 Used with Hershey’s 64 oz pouches with 16mm fitments. Thank You ...for purchasing this dispenser. The reliable, reusable pump lasts for years while the environmentally friendly pouch system minimizes landfill impact.
- Page 2 87952 DISPENSER PARTS PUMP MODEL: BP-1 UNIT MODEL: SPPH PUMP 88548 COMPLETE UNIT 87952 PUMP DELIVERS 1 OZ PORTIONS To reduce portion, add optional GAGING COLLAR(S) onto side of head assembly 88313 Small collar: 1/8 oz reduction 88204 Medium collar: 1/4 oz reduction 88205 Large collar: 1/2 oz reduction HEAD PUMP...
- Page 3 DISASSEMBLY DISASSEMBLE AND WASH ALL PARTS PROPERLY BEFORE USE. See page 4. During disassembly, collect small parts in a container to prevent loss. REMOVE LID, PUMP & POUCH from vessel. DETACH POUCH from bottom of pump. SEPARATE LID FROM PUMP Unscrew cap from threaded insert in lid to remove pump.
-
Page 4: Pump Cleaning
SAFETY IMPORTANT According to food and safety regulations, most foods must be stored and/or served at certain Clean, rinse, sanitize, and dry parts daily or regularly temperatures or they could become hazardous. to comply with local sanitization requirements. Check with local food and safety regulators for specific guidelines. -
Page 5: Care Of Stainless Steel
CLEAN-IN-PLACE PROCEDURE FOR PUMPS CLEAN • Pump out all (if any) remaining food product from inside pump body. • Wash and rinse off outside of pump body. • Flush out and rinse inside of pump. • Place lower end of pump into container full of water and operate pump until all (if any) remaining product is expelled and only warm water flows from discharge... - Page 6 ASSEMBLY PRACTICE SAFETY. WASH ALL PARTS PROPERLY BEFORE USE. See page 4. INSTALL O-RING into seal. Apply food equipment lubricant on O-ring INSTALL SEAL onto head assembly piston. Apply small amount of food equipment lubricant inside seal. TIP: Flared end of seal should face away from piston head.
- Page 7 INSTALL HEAD ASSEMBLY INTO CYLINDER Apply a small amount of food equipment lubricant to the outside of seal. Slide locking collar down onto cylinder threading. Tighten firmly to secure head assembly to cylinder. PREPARE LID Fit threaded insert into lid hole. Screw lower collar onto threads that descend below lid hole.
-
Page 8: Troubleshooting
TROUBLESHOOTING PRODUCT OOZES OUT FROM LOCKING COLLAR? • Check the seal. TIP: Seal has a slight taper. Install with flat side towards top, flared side down. INCONSISTENT PORTIONS? • Clean pump. • Ensure product container is not empty and has enough product to pump. •...