Audiovox Alarm Clock Am/FM with CD Player Instruction Manual

1. Press the STANDBY button to turn to function mode.
2. Press OPEN button to insert a CD into the slot with printed side
facing upward and close the door.
3. Press the FUNCTION button to select CD mode. After loading the
CD, total tracks of the disc will be shown.
4. Press the button to begin play.
Note:
LCD display will return to Clock
mode after about 15 sec with no
further operation.
To Interrupt Playback
• Press the button.
• To resume playback, press the button again.
To Stop Playback
• Press the button.
To Remove the Disc
• Press the OPEN button and take the CD out.
To Review CD Track No.
• Press to review CD track no.
Note: This operation will cause instant stop of track playing.
Track Search - Locating a Particular Point In a Track
• Keep the or button pressed during play and release at the
desired point.
- 9 -
The TUNER, CD or BUZZER automatically sounds at the designated
time everyday. You can set two different kinds of alarm time, one for
ALARM 1 and the other for ALARM 2.
Setting Alarm 1 (Same As Setting ALARM 2)
1. Press STANDBY button to return to clock mode.
2. Press ALARM 1 button until " "
and alarm time start to flash.
Note:
If ALARM 1 button is pressed
again, this operation will go cycle
until wake up mode (TUNER, CD
or BUZZER) is confirmed by
pressing MEMORY/SET button.
3. Press button to adjust hour.
4. Press button to adjust minute.
5. Press MEMORY/SET button to
confirm Alarm 1 wake up time.
And " " appears on the display
which means ALARM 1 has
been set.
- 12 -
Tracks Skip - Skipping To The Previous or Next Track
• Press the button once to return to the beginning of the current
track.
• Press the button repeatedly to skip tracks backward one by one.
• Press the button repeatedly to skip tracks forward one by one.
Repeat Play
This function will allow a single track or all tracks on the disc to be
played repeatedly. REPEAT function can be operated when playing
a disc.
1. To repeat the same track, press
the PRESET/REPEAT button
until "REPEAT" icon lights up
on the display.
2. To repeat the disc, press the
PRESET/REPEAT button until
"REPEAT ALL" icon lights up
on the display.
3. To cancel repeat play, press
the PRESET/REPEAT button
until "REPEAT" icon
disappears from the display.
Note:
LCD display will return to Clock mode after about 15 sec with no
further operation.
Program Play
Program play allows the selected tracks play in desired order.
Program function can only be operated in stop mode.
1. Turn on the power and press the FUNCTION button to select CD
mode.
- 10 -
Alarm On with Tuner, CD and Buzzer
When the designated alarm time comes,
the selected sound source (TUNER, CD
or BUZZER) will be triggered and the
ALARM symbol will start to flash.
Turn Off the Alarm
To turn off the alarm, press STANDBY, ALARM 1 or ALARM 2 button.
The alarm will go off instantly until the same time next day.
Important note:
In case of wake up with TUNER or CD, no other operation such as
CD Stop can be made until turn off the alarm by pressing STANDBY,
ALARM 1 or ALARM 2, and then change the unit to TUNER or CD
mode for further operations.
To Review the Set Alarm Time
• Press ALARM button while the unit is in power off.
To Cancel Alarm Mode
• Press ALARM button until all wake up modes (TUNER, CD or
BUZZER) disappear from the display, then press MEMORY/SET
button to confirm.
Snooze
• Press SNOOZE button allows you to enjoy another 5 minutes'
sleep. Alarm will be on again after 5 minutes of each press of
SNOOZE button until STANDBY, ALARM 1 or ALARM 2 button is
pressed.
- 13 -
2. Press MEMORY/SET button (in stop mode), first " " will appear
for about 2 seconds and then " " will flash on the display.
3. Press or button to select the desired track. Then press
MEMORY/SET button to store the track in memory.
4. To add additional tracks, repeat setp 2 ~ 3.
Notes:
• Check the program order.
• Press MEMORY/SET button repeatedly.
• To stop program play, press STOP button or select other function
by pressing FUNCTION button.
• The same track can be selected more than once in the same
program.
• A maximum of 20 tracks can be programmed.
• With program on, the or skip function is available only for the
selected tracks.
• REPEAT play can be performed during program play.
Connect headphones (Dia. 3.5mm
stereo mini plug) to the PHONE
jack. When the headphones are
connected, speaker sound will be
automatically disconnected.
- 11 -
General Guidelines
• Do not touch the laser lens on the CD player.
• Temperature changes may cause condensation on the laser lens.
If condensation forms on the lens, leave the unit for about an hour
until condensation evaporated.
• Do not leave the unit exposure directly under sunlight or extreme
heat such as inside a car parked in the sun. This can cause damage
or malfunction.
• To prevent dust from reaching internal components, do not leave
compartment door such as back up battery door opened at all time.
• Do not cover unit with cloth.
Handling of Compact Disc
• Although the music tracks in the disc are covered with enclosure,
it is still advisable to treat the disc carefully. Always pick up the disc
by the edge and put them back in the holders immediately after use.
• Always wipe the compact disc from centre to the edge of disc with
a piece of velvet or soft dry cloth.
CD
Problems Solutions
System does not turn • Make sure the STANDBY button is set to
on. ON.
• Make sure press the FUNCTION button to
Disc in place but unit CD mode.
won't play. • Make sure disc is clean and undamaged.
• Make sure printed side of disc is facing up.
• Make sure PAUSE mode is not activated.
- 14 -
Alarm Clock
AM/FM Radio
With CD Player
For best results, please read this manual carefully before using the
unit.
WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE THE UNIT TO RAIN OR
MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN
THE CABINET.
REFER SERVICING TO QUALIFIED
PERSONNEL ONLY.
RADIO
Problems Solutions
Poor FM reception • Make sure FM antenna wire is fully extended.
• Electrical interference in your home can
cause poor reception. Move the unit away
from them (especially those with motors
and transformers).
Poor AM reception • Rotate the unit horizontally.
CLOCK
Problems Solutions
Clock does not show • There has been an electrical power
the correct time. interruption.
Alarm does not come To turn on the TUNER, CD or BUZZER alarm,
on at the preset time. check the following points:
• Is the current time correctly set on the time
display? Check the AM/PM indication.
• Is the alarm time correctly set? Check the
AM/PM indication.
• Is the desired station tuned in?
Power consumption: 8W
Power requirements: AC 120V - 60Hz
DC 9V
Specifications are subject to change without notice.
Printed in China 811-308091-010