Advertisement
Quick Links
Quick Star t Guide
802.11ac Outdoor Stand-Alone Access Point
SkyFire™ AC1200 and SkyFire™ AC866
www.ignitenet.com
The AC1200 and the AC866 are single- and dual-band access points (APs) that are
housed in a waterproof enclosure for mounting outdoors. The units include a built-
in mounting bracket for attaching to a 1.5 to 6-inch pole and they can be powered
through their Ethernet cable connection from a power injector module that is
installed indoors.
The Outdoor Stand-Alone Access Points include these models:
◆
SF-AC1200 — dual-band w/integrated 5 GHz antenna and 2x RP-SMA (2.4 GHz)
◆
SF-AC1200-1 — dual-band w/ 2x RP-SMA (5 GHz) and 2x RP-SMA (2.4 GHz)
◆
SF-AC1200-2 — dual-band w/integrated 5 GHz antenna and 2.4 GHz antenna
◆
SF-AC866 — single-band w/integrated 5 GHz antenna
◆
SF-AC866-1 — single-band w/ 2x RP-SMA (5 GHz)
Note:
For Safety and Regulatory information, refer to the Safety and Regulatory
Information document included with the AP.
– 1 –
Advertisement
Summary of Contents for Ignite SF-AC1200
- Page 1 ◆ SF-AC1200 — dual-band w/integrated 5 GHz antenna and 2x RP-SMA (2.4 GHz) ◆ SF-AC1200-1 — dual-band w/ 2x RP-SMA (5 GHz) and 2x RP-SMA (2.4 GHz) ◆ SF-AC1200-2 — dual-band w/integrated 5 GHz antenna and 2.4 GHz antenna ◆...
- Page 2 Quick Start Guide Follow the steps in this guide to install the AP in your network. Caution: The planning and installation of the AP requires professional personnel that are trained in the installation of radio transmitting equipment. The user is responsible for compliance with local regulations concerning items such as antenna power, use of lightning arrestors, grounding, and radio mast or tower construction.
-
Page 3: Connect Cables
Quick Start Guide Attach External Antennas Remove the front port cover by pushing the locking tab up and then sliding the cover off. Connect external antennas to the AP’s 5 GHz RP-SMA connectors using RF coaxial cable provided in the antenna package. -
Page 4: Verify Ap Operation
Quick Start Guide Connect the Ethernet cable from the AP to the “POE” port on the power injector. Connect Ethernet cable from the “LAN” port on the power injector to a LAN switch. Connect the power cord to a nearby AC power source (100-240 VAC, 50/60 Hz). -
Page 5: User Interface
Quick Start Guide 6. Connect to the Web The stand-alone APs offer a web-based management interface for the User Interface configuration of all the unit’s features. You can make initial configuration changes by connecting a PC directly to the AP’s ETH1 RJ-45 port. -
Page 6: Hardware Specifications
Quick Start Guide Hardware Specifications Item Specification Chassis Size (H x W x D:) 283 x 94 x 50 mm (11.14 x 3.7 x 1.97 inches) Weight 762 g (1.68 lb) Temperature Operating: -20 °C to 65 °C (-4 °F to 149 °F) Storage: -30 °C to 80 °C (-22 °F to 176 °F) Humidity Operating: 15% to 95% (non-condensing)