Advertisement
Quick Links
T02-00004-0201/T02-00004-0202
Horn Speaker
Installation Instructions
Introduction
The T02-00004-0201 horn speaker (for 25W
radios) and the T02-00004-0202 horn speaker (for
30-50W radios) can be mounted externally on the
vehicle so that radio traffic can be heard when
personnel are outside the vehicle. The horn
speaker is connected to the radio's speaker out
terminals.
The horn speaker is supplied with a 20ft (6m)
extension cable, and a flying lead.
The flying lead is terminated with two
receptacles. The receptacles of the
T02-00004-0201 (for 25W radios) are different
from those for the T02-00004-0202 (for 30-50W
radios). Two spare receptacles are included with
each kit.
Alert Symbol and Message Conventions
Please follow exactly any instruction that appears in the text as an 'alert'. An alert provides
necessary safety information as well as instruction in the proper use of the product. This
document uses the following types of alert:
Warning This alert is used when there is a hazardous situation which, if not
avoided, could result in death or serious injury.
Caution This alert is used when there is a hazardous situation which, if not avoided,
could result in minor or moderate injury.
Notice This alert is used to highlight information that is required to ensure procedures
are performed correctly. Incorrectly performed procedures could result in equipment
damage or malfunction.
This alert is used to highlight significant information that may be required to ensure pro-
cedures are performed correctly, or draw your attention to ways of doing things that can
improve your efficiency or effectiveness.
© Tait Limited April 2013
www.taitradio.com
402-00090-01
extension
cable
receptacles
horn
speaker
cable
flying lead
Advertisement
Summary of Contents for Tait T02-00004-0201
- Page 1 T02-00004-0201/T02-00004-0202 Horn Speaker Installation Instructions Introduction The T02-00004-0201 horn speaker (for 25W radios) and the T02-00004-0202 horn speaker (for 30-50W radios) can be mounted externally on the vehicle so that radio traffic can be heard when personnel are outside the vehicle. The horn speaker is connected to the radio's speaker out terminals.
- Page 2 Caution Do not stand or sit on, nor hang down from the horn speaker as this may cause the speaker to fall down or drop. Notice When installing the horn speaker, be sure that water and snow cannot accumu- late inside the horn. T02-00004-0201/T02-00004-0202 Horn Speaker © Tait Limited April 2013...
- Page 3 Connect the black (positive) wire of the speaker cable to the red wire of the ■ extension cable. Connect the white (negative) wire of the speaker cable to the black wire of the ■ extension cable. The extension cable is a 20 AWG cable. T02-00004-0201/T02-00004-0202 Horn Speaker © Tait Limited April 2013...
- Page 4 (black) T02-00004-0202 horn speaker (30-50 W radios) Tait recommends using insertion tool M81969/18-02 (Tait P/N 355-00001-00). Insert the wire with the white stripe (positive) and receptacle into position 3. ■ Insert the black (negative) wire and receptacle into position 2.