Related Manuals for Oreck SIMPLY AMAZING APU255
Summary of Contents for Oreck SIMPLY AMAZING APU255
- Page 1 S I M P L Y A M A Z I N G ™ ’ UIDE APU255 •IMPORTANT• SAVE THIS BOOKLET! Includes: • Safety Warnings • Warranty • Operating Instructions • Trouble Diagnosis • Accessories...
-
Page 2: Table Of Contents
....page aintenance and ustomer ervice Your ORECK vacuum cleaner is a product of precise engineering. The motor bearings are permanently lubricated and should not be oiled. If you require additional information or have problems with your... -
Page 3: Warranty
God, the use of voltages other than indicated on the serial number plate of this product or service of this product by other than ORECK or an ORECK Factory Authorized Service Center. ORECK does not authorize any person or representative to assume or grant any other warranty obligation with the sale of this product. -
Page 4: Operating Instructions
Power Switch Push power switch to “ON” (l) position. Power Nozzle Operation Your ORECK ELECTRIKBROOM cleaner features a power brush nozzle designed for effective cleaning on all types of carpets or bare floors. When cleaning rugs or floors, glide the nozzle with slow, easy strokes. -
Page 5: To Replace Filter Bag
To ensure that your ORECK ELECTRIKBROOM Powerbrush cleaner provides you with optimal performance, use only ORECK brand bags. Replace the filter bag more frequently when picking up fine materials such as powders, plaster dust, ashes and soot. These materials may seal the filter bag before it appears full. -
Page 6: To Replace Belt
Reattach swivel clamp to nozzle base. SCREWS To order: Replacement Belts Call your authorized ORECK Service Centerr, your authorized ORECK dealer, or the ORECK Service Center Hotline toll free at: Part No. OR114 US: 1-800-989-3535 CANADA: 1-800-393-8801... -
Page 7: To Clean Clogged Power Nozzle
WARNING: Unplug cord from electrical outlet before servicing. STEP 1: Remove Power Nozzle Assembly Lay cleaner on flat surface with bottom side of nozzle (brush side) facing you then: A) Remove swivel clamp screws and clamp. B) Remove the two screws at the outer rear corners of the nozzle base plate only. -
Page 8: Accessories
OR162 2. Belts, 2 Pack OR114 All word marks, logos, product configurations, and registered trademarks are owned and used under the authority of Oreck Holdings, LLC. © 2001 Oreck Holdings, LLC. All Rights Reserved. Printed in America 26852-03 REV B...