Bush ELED42240FHDCNTD3D Installation & Operating Instructions Manual page 19

Connections
Side AV Connections
You must use the supplied SIDE AV connection
cable for enabling SIDE AV connection.
1. Plug single jack of the cable to the TV's SIDE
AV socket.
2. Insert your AV cable's (not supplied) connectors
into the plural part of the SIDE AV connection
cable (see illustration below). Colours of the
connected jacks should match.
3. To enable audio connection, use an audio
cable. Insert your device's audio cable's
connectors into the plural part of the SIDE AV
connection cable. Colours of the connected
MDFNV VKRXOG PDWFK ¿J1).
4. :KHQ WKH FRQQHFWLRQ LV PDGH VZLWFK WR FAV
source.
Using a Conditional Access Module
IMPORTANT: Insert or remove the CI module
only when the TV is SWITCHED OFF.
In order to watch certain digital channels, a
conditional access module (CAM) can be
necessary. This module must be inserted in the CI
VORW RI \RXU 79 ¿J 2).
1. Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert those to the TV using the
following procedure.
2. Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the rear
side of the TV.
3. The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The CAM
or the TV terminal may be damaged if the CAM
is forcefully inserted.
4. Connect the TV to the mains supply, switch
on and then wait for few moments until the card
is activated.
5. :KHQ QR PRGXOH LV LQVHUWHG ³No Common
Interface module detected" message appears
on the screen.
You can refer to the module instruction manual for
details of the settings.
For any help concerning set up and use of your TV please call the Customer Helpline: 0044 845 604 0105
¿J1)
¿J2)
19