Aerial & Cable Connection; Power Connection; Wall Mounting; Remote Control - Inserting Batteries - Bush ELED42240FHDCNTD3D Installation & Operating Instructions Manual

Getting Started
Aerial & Cable connection
Connect the "aerial" or "cable TV" plug to AERIAL INPUT
(ANT. VRFNHW ORFDWHG RQ WKH EDFN RI WKH 79 ¿J1).

Power connection

IMPORTANT :The TV set is designed to
operate on 220-240V AC, 50 Hz.
Please note: After unpacking, allow the TV
to reach ambient room temperature before
connecting the TV to the mains power socket.
Connect the power cord plug to the mains power socket.
The LED on the front of the TV then lights up, this
indicates that the TV is in 'Standby' mode.

Wall Mounting

:KHQ ZDOO PRXQWLQJ SOHDVH HQVXUH \RX XVH D
compatible wall mount (not supplied). This TV
FRQIRUPV WR WKH 9(6$ PRXQWLQJ VSHFL¿FDWLRQV DQG
is 200 x 200mm.

Remote control - Inserting batteries

Remove the battery cover on the back of the remote
control, gently push down and pull backwards at the
same time as shown.
Insert two AAA/R3 or equivalent type batteries.
Ensure the batteries are inserted the correct way
DQG UHSODFH WKH EDWWHU\ FRYHU ¿J2).
NOTE: When the remote control is not going
to be used for long periods of time, the batteries
should be removed. Otherwise the remote control
may be damaged, caused by battery leakage and
corrosion.

Switching the TV On and Off

To Switch the TV On

Connect the power cord to the 220-240V AC,
50 Hz.
To switch on the TV from standby mode either:
Press the " " button, P+ / P- or a numeric button
on the remote control.
Press the " " button, P+ / P- or a numeric button
on
the TV.
Press the side function switch until the TV comes
on from standby.
For any help concerning set up and use of your TV please call the Customer Helpline: 0044 845 604 0105
VGA
SPDIF
AAA/R3 x 2 Batteries

To Switch the TV Off

Press the " " button on the remote control
or hold
the " " switch on the Tv until shut down, so
the TV
will switch to standby mode.
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby
mode, the standby LED can blink to indicate
that features such as Standby Search, Over
Air Download or Timer is active. The LED can
also blink when you switch on the TV from
standby mode.
Aerial or Cable
¿J1)
¿J2)
13