Page 1
(A60-2427-08) u163 In compliance with Federal Regulations, following are repro- KENWOOD Corp. certifies this equipment conforms to DHHS duction of labels on, or inside the product relating to laser Regulations No.21 CFR 1040. 10, Chapter 1, subchapter J. product safety.
Page 3
RXD-M47MP 3 7 63 1515 0 EXTERNAL VIEW Antenna cover (F07-2029-08) Rear cabinet (A80-4503-08) L 13942296513 Speaker terminal (E70-0196-08) AC power cord (E30-7343-08) u163...
Page 4
RXD-M47MP 3 7 63 1515 0 ADJUSTMENT SERVICE ADJUSTMENT Lubrication The mechanical parts are factory coated with a thin coat of light grease and should not require further lubrication. If a light grease is applied, be careful not to get any grease on the play/record head or erase head, hubs, pulleys, tapes reels, drive belts, or switches.
Page 5
RXD-M47MP 3 7 63 1515 0 ADJUSTMENT Play/Record and Playback Head Azimuth Adjustment To adjust the play/record and playback head azimuth screw: 1. Connect two (2) VTVMs and a dual trace scope to the stereo headphone jack (as shown) with a 32 ohm dummy load.
Page 6
RXD-M47MP 3 7 63 1515 0 ADJUSTMENT Tape Speed Adjustment 1. Set the function switch to TAPE. 2. Connect a frequency counter with a 32 ohm dummy load to the stereo headphone jack. (See Figure 3.) FREQUENCY COUNTER JK801 DUMMY LOAD Figure 3.
Page 7
RXD-M47MP 3 7 63 1515 0 ADJUSTMENT TUNER ALIGNMENT PROCEDURE Equipment needed: 1. AM Signal generator 2. FM Signal generator 3. DC Voltage meter 4. Oscilloscope 5. Output meter (VTVM) AM Alignment Step S/G Frequency Dial Setting Indicator Adjust Remarks 450 kHz (1 kHz 30% mod.)
Page 8
RXD-M47MP 3 7 63 1515 0 ADJUSTMENT FM Alignment: TEST UNIT GROUND METER Figure 6. FM Band Frequency Coverage Alignment Connect FM S/G to ANT inputs (mod 1 kHz 22.5kHz dev.) Step S/G Frequency Dial Setting Indicator Adjust Remarks 87.5 MHz...
Page 9
PC BOARD (Component side view) 3 7 63 1515 0 FRONT KEY SW107 POWER SW100 LED182 LED181 CN110 SW101 Q182 CN112 TUNER LED180 /BAND R169 R170 R171 SW102 R172 R161 C118 C117 C180 TAPE CN111 SW113 TIME SET TIMER ON/OFF SW108 SW104 SW109...
Page 16
Desti- Add- Ref. No Parts No. Description Ref. No Parts No. Description ress Parts nation marks marks ress Parts nation POWER SUPPLY RXD-M47MP C901 CE04KW1C221M ELECTRO 220UF 16WV ✻ A05-0270-08 Speaker Box 00-00337-03 ✻ C902 C91-1706-08 CERAMIC 0.1UF ✻ B60-5521-08 I/B ‘Kenwood’...
Page 17
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 18
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 19
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 20
3 7 6 3 1 5 1 5 0 ✽ New Parts ✽ New Parts Parts without Parts No. are not supplied. Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Les articles non mentionnes dans le Parts No.
Page 21
3 7 6 3 1 5 1 5 0 ✽ New Parts Parts without Parts No. are not supplied. Les articles non mentionnes dans le Parts No. ne sont pas fournis. Teile ohne Parts No. werden nicht geliefert. Add- Desti- Ref.
......... 87.5 MHz ~ 108 MHz AM tuner section Notes: Tuning frequency range KENWOOD follows a policy of continuous advance- ......... 531 kHz ~ 1,602 kHz ments in development. For this reason specifications may be changed without notice. CD player section Sufficient performance may not be exhibited at ex- Laser ......