INTRODUCTION Congratulations on your selection of a QCM desktop cutter. We are certain you will be pleased with the purchase of this fine machine. Please read this manual carefully before putting the machine into operation. Keep this manual handy for future reference. It is considered a permanent part of the machine and should remain with the machine if resold.
SAFETY PRECAUTIONS When operating this machine the following safety precautions must be observed. ● This machine is designed for single person operation only. No more than one person is allowed to operate the machine at a time. ● Under no circumstances should children be allowed to operate the machine. Keep the machine out of the reach of children.
Caution: After each cutting operation, always make sure to lift the cutting bar lever back to the up position until the blade safety lock is engaged. 7. Release the clamp by rotating the clamp wheel counter-clockwise. Remove the paper stack from the machine.
Page 5
1. Locate the necessary tools. You need one blade holder (supplied with the machine) and one #2 philips screwdriver. 2. Place the machine on a flat, stable surface located in a traffic-free area and face the blade carrier side towards you. Fold down the support extender as shown in figure 2.
7. Repeat steps 5 and 6 until it a clean cut through a piece of paper is made. 8. Follow steps 2 through 4 in reversed order to mount the front cover. TECHNICAL SPECIFICATIONS Model Number: QCM-8200M QCM-8700M Cutting Width: 12-3/8″...