TP-Link TL-WPA4230P Quick Installation Manual

Quick Installation Guide
AV500 Passthrough Powerline Wi-Fi Extender
Applicable to TL-WPA4230P and its multiple-pack kits
* TL-WPA4230P KIT (European version) is used for demonstration in this QIG.
Image may di er from actual product.
7106505539 REV2.0.1

Plug and Play

Set Up a New Wireless Network
Adapter
(TL-PA4020P)
e
r l i n
w e
P o
N
L A
Router
N
W A
Extender
(TL-WPA4230P)
2
1
Wait until the Powerline
LED turns on.
3
Clone Your Router's Wi-Fi Settings to the Extender (Recommended)
If your router supports WPS, you can continue with the steps below to clone
its current Wi-Fi settings to the extender.
Tips: We recommend that you plug in the extender near your router for Wi-Fi cloning.
1
Press the WPS button
for 2 seconds.
Wireless Router
WAN WPS LAN
Note: If the Wi-Fi LED still blinks slowly for longer than 30 seconds, unplug the extender and plug
it back in, then try again. Or use "Customize the Extender's Wi-Fi Settings" on the back instead.
More: To add additional powerline
adapters and powerline Wi-Fi extenders
with the default settings, simply plug them
into the wall sockets on the same electrical
circuit.
4
Enjoy!
Use the default wireless network name
(SSID) and password on the provided Wi-Fi
Info Card to access the Internet.
2 3
Within 2 minutes, press Done.
the Wi-Fi Clone button for
1 second.
15
250
Solid on for 5 seconds
500Mbps and then blinks rapidly
Blinks slowly for
about 10 seconds