Before Assembly Read and Save These Safety Precautions Make sure that the fan voltage (120) is compatible with your own electrical Turn off electricity at main switch before wiring or servicing fan in order to avoid system. possible electrical shock. Check to make sure that your carton contains all the parts mentioned in the All wiring must be in accordance with the National Electric Code (ANSI/NFPA parts list.
Preparation / Preparación What You Have/Componentes Incluidos Important: When using an existing outlet box, be sure the box is securely attached Parts Quantity to the building structure and can support the full weight of the fan. Failure to do so Piezas Cantidad can result in serious injury or death.
Page 4
Step 4 / Paso 4 Step 3 / Paso 3 Hang the fan motor/outer housing (#2) onto the hook that is positioned Secure mounting plate (#1) using screws and washers (S2) directly to the on the mounting plate (#1). outlet box. Arrows on mounting plate and fan body inner housing plate will line up (see step #6).
Page 5
Step 5 / Paso 5 Step 5 Continued… Paso 5 Continuación… 1. Connect fan wires to ceiling wires: white fan wire to white outlet wire, black to black and green to green. Wire connectors (S5) are provided for your convenience. If an additional blue wire is present then also connect the blue wire to the black wire.
Page 6
Step 6 / Paso 6 Step 7 / Paso 7 Line up arrow on mounting plate (#1) to arrow on fan body inner housing For blade assembly, position blade arms and blade (#4) so that all screw plate (#2). Push outer housing (#2) up and twist clockwise approximately holes are aligned (as shown in figure below).
Page 7
Operation Instructions / Instrucciones de uso Electrical Connections / Conexiones eléctricas Operation Instructions / Instrucciones de uso Electrical Connections /Conexiones eléctricas 1. The sequence of operation for the motor pull/chain switch is OFF- Connect black and blue (if provided) fan wires to black outlet wire. HI-MED-LOW.
Common Problems Electrical Connections Continued… Conexiones eléctricas Continuación… Problem A: Fan Will not Start Remedies: 1. Check fuse or circuit breaker and replace if necessary 2. Check that pull chain switch is on and that slide switch is up or down. Ground/ Tierra 3.