Provari Procyon Adapter; Batteries; Charging A Battery - Provape PROCYON Owner's Manual

ProVari Procyon Adapter

The ProVari Procyon features a standardized thread (P3 thread) which allows the user to easily switch
between 510-style threads, Ego-type threads and any new hardware equipped with properly designed P3
threads. On the top of the 510 thread we have added coin slots so you can tighten the connector using a
penny or dime. It's best to tighten this connector so it does not come off when you remove your tank.
Not only is the P3 thread stronger and more robust than most other attachment systems available, it also
features specially designed adapters to allow the use of virtually any atomizer, tank or cartomizer
available on the market today.

Batteries

We recommend you only use IMR high drain batteries in this device. This will give you the full range of
output power needed to use the device. Only use approved batteries. Always feel free to contact us if you
are not sure which batteries to use. To ensure you get the correct batteries you should always purchase
them at www.ProVape.com.
The ProVari Procyon operates on a single 18650 battery. Never stack two batteries.
Only use the Samsung 25R in the ProVari Procyon.
Never use magnets on your batteries as this is very dangerous.

Charging a Battery

Plug the charger unit into an appropriate power supply.
Insert a battery into the charger and make sure you put the battery in the correct direction.
Align the positive (+) end of the battery with the positive (+) mark on the charger.
The LED on the charger will glow red when the batteries are charging.
The LED on the charger will glow green when the batteries are charged.
(This could vary depending on the charger that you purchased)
Do not attempt to charge other types of batteries in the battery charger.
The ProVari uses a special kind of battery. Only use approved rechargeable cells.
NEVER use alkaline batteries and never try to charge an alkaline battery.
ProVari Procyon 510-adapter and trim ring
9