Warning Messages and Fixes
Warning Message
OUTPUT TOO HIGH OR BAD ATOMIZER [1]
OUTPUT CURRENT HIGH [2]
OUTPUT TOO HIGH [3]
TEMPERATURE HIGH [4]
TEMPERATURE HIGH [5]
OUTPUT FAULT [6]
OUTPUT FAULT [7]
INTERNAL FAULT [8]
INTERNAL FAULT [9]
BATTERY VOLTS HIGH [10]
OUTPUT TOO HIGH OR BAD ATTY [20]
INPUT QUALITY POOR / BAD - OUTPUT LIMITED [30]
LOW INPUT VOLTS DUE TO POOR INPUT QUALITY OR BAD
BATTERY [34]
ATTY OHMS FAULT [35]
Warning Message Details
In the event that you get an error message, the Procyon will alert you on screen as to the reason for the
error and the suggested fix. Above is a list of the error messages that can occur.
Reduce Watts or Change Atomizer - If the atomizer ohms are too high or your output wattage is set too
high this error can occur. Try lowering the power level or change your atomizer.
Increase Watts or Change Atomizer - There are situations where you need to increase the watts. For
example, if you set the device to 3 watts and try to use a low resistance atomizer, the device cannot drive
power at that level. This scenario will prompt this error.
Reduce Watts or Replace Atomizer – This error can occur if the wattage is set too high and Procyon
cannot safely power the atomizer with your current settings. This can also happen if you have the wattage
set too high along with the boost mode set too high. Try lowering your settings. Most of the time, if you
have these power settings too high, you will be burning the juice and it won't taste very good or you risk
burning out your atomizer.
Replace Atomizer and Try Again – This can happen if the resistance of your atomizer is too low or has
failed. Anytime the resistance of your atomizer drops, in most cases it has burned up or failed. This can
also occur if you make your own coil on a RBA and you go below the resistance level that the device can
drive. Typically this is anything below .40 ohms. Try installing a new atomizer and see if the problem goes
away.
Let Cool and Replace Battery – While these are very rare error messages, the system is monitoring for
an unsafe condition with your battery. If your battery ever gets too hot and it's not safe to use, carefully
remove the battery and discard. If the unit is too hot, it's best to set it down and wait for it to cool off
before removing the cell. Anytime you have a battery fail, always discard the cell and replace it with a new
REDUCE VOLTS / WATTS OR REPLACE
>>>
>>>
REPLACE ATOMIZER AND TRY AGAIN
>>>
>>>
LET COOL AND REPLACE BATTERY
>>>
LET COOL AND REPLACE BATTERY
>>>
>>>
REPLACE ATOMIZER AND TRY AGAIN
>>>
>>>
>>>
>>>
>>>
CHECK BATTERY, CONTACTS AND SPRING
>>>
CHECK BATTERY, CONTACTS, AND SPRING
>>>
27
Suggested Fix
ATOMIZER
REDUCE VOLTS / WATTS
RETURN FOR REPAIR
RETURN FOR REPAIR
RETURN FOR REPAIR
USE CORRECT BATTERY
REDUCE WATTS
CHANGE ATTY
Need help?
Do you have a question about the PROCYON and is the answer not in the manual?