Louroe Electronics MLA-6 Installation And Operating Instructions Manual

6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
techsupport@louroe.com
AD-1 POWER SUPPLY
The MLA-6 and MLA-8 are microphone mixers with six and eight audio inputs and one audio output
respectively. They are designed to combine up to six and eight microphones (or up to four
speaker/microphones) to expand the listening area of an audio zone. The MLA-8 is located between the
microphones (or speaker/microphones) and the Louroe base station. In addition, it has a line driver amplifier
that allows for runs up to 5,000 ft. between the MLA-8 and the Louroe base station and up to 1,000 ft. between
the MLA-8 and the remote microphone (or speaker/microphone) for a total of 6,000 ft
WIRING REQUIREMENTS:
Microphone Only:
®
Louroe Verifact A, B, C, D, D-V, E, K or L-DT
Microphone/Speaker
Louroe Model TLI, TLM, TLMC, TLO, TLSP
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX
®
/ www.louroe.com
RCA CABLE
®
website: www.louroe.com
MLA-6/MLA-8
MICROPHONE MIXER
INSTALLATION AND OPERATING INSTRUCTIONS
MODEL MLA-6
WIRING REQUIREMENTS
e-mail: sales@louroe.com
Page 1 of 8
THIS INSTALLATION INSTRUCTION APPLIES
TO BOTH MLA-6 AND MLA-8 (SHOWN). THE MLA-8
IS USED IN THIS INSTALLATION INSTRUCTION
MODEL MLA-8
.
2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire
NOTE: Unshielded cable is not
satisfactory for audio systems
West Penn 452 or equivalent
WIRING REQUIREMENTS
4 Conductor consisting of:
2 Conductor shielded, 20 gauge
with 22 gauge drain (microphone
connection)
2 Conductor unshielded, 18 gauge
(speaker connection)
All in the same jacket
West Penn 356 or equivalent
(818) 994-6458
mla_6/8_inst_3/15