Page 1
PROJECTION TV RECEIVER Chassis : J51A(REV. 1) Model : SP43J5HFX/SED SP43J5HFX/RAD SP53J5HFX/RAD SP61J5HFX/RAD PROJECTION TV RECEIVER C O N T E N T S Precautions Reference Information Specifications Alignment and Adjustments Troubleshooting Exploded View and Parts List Electrical Parts List...
Initial display when the service mode is switched. 1. When a RF signal is received SERVICE MODE GEOMETRICS PICTURE PICTURE2 OPTIONS RESET 2. When the PC mode is received F.MENU (Press to MAIN MENU ZOOM COMPRESS FREEZE SET UP RESET EXIT Samsung Electronics...
Page 3
CH UP/DOWN Select item by moving cursor VOL UP/DOWN Decrease or increase the adjustment values Note : The PC mode can be switched to the service mode by pressing the F.Mode Key (only on the factory remote control). Samsung Electronics...
Page 4
OFF, TV OUT, MONITOR OUT THAI ON, OFF LANGUAGE MULTI-12 Eng, Arab, French, Thai, Russian, Croatian, Polish, Turkish, Hungaran, Iran, Pakistan, Hindi MidEast Eng, Arab, French, Turkish, Iran, Pakistan Asia Eng, Thai, Hindi Russia Eng, Russia M. Europe Eng, Croatian, Polish, Hungaran Samsung Electronics...
Page 5
OFF, TV OUT, MONITOR OUT THAI ON, OFF LANGUAGE MULTI-12 Eng, Arab, French, Thai, Russian, Croatian, Polish, Turkish, Hungaran, Iran, Pakistan, Hindi MidEast Eng, Arab, French, Turkish, Iran, Pakistan Asia Eng, Thai, Hindi Russia Eng, Russia M. Europe Eng, Croatian, Polish, Hungaran Samsung Electronics...
Page 6
OFF, TV OUT, MONITOR OUT THAI ON, OFF LANGUAGE MULTI-12 Eng, Arab, French, Thai, Russian, Croatian, Polish, Turkish, Hungaran, Iran, Pakistan, Hindi MidEast Eng, Arab, French, Turkish, Iran, Pakistan Asia Eng, Thai, Hindi Russia Eng, Russia M. Europe Eng, Croatian, Polish, Hungaran Samsung Electronics...
Alignment and Adjustments 4-2 Screen Change (When adjusting I C Bus Geometric items) V SIZE V SHIFT V LINEARITY V - S - CORRECTION H SIZE PIN PHASE PIN AMP H SHIFT V BOW V ANGLE Samsung Electronics...
5. Adjust the Red lens using the same method as with the Green lens. 6. Note: The Blue lens is not adjusted because its focus varies little (VM-coil is installed). 7. After the adjustments are completed, disconnect the jig pin connector. Samsung Electronics...
2. Adjust VR471 (located on the deflection board) so that the digital meter indicates 9. Adjust the high light with viewing the light DC 31V ± 0.1V. side of the screen. 10. If necessary, redo adjustments 6~9. 11. Press the Menu key to exit. Samsung Electronics...
Page 10
Set the Red lens at the point where Orange becomes Crimson. 7. Blue lens adjustment Set the Blue lens at the point where Purple becomes Green. Examine these points together Fig. 4-1 Crosshatch Pattern. RED ABERRATION BLUE ABERRATION L1, L2 < P Fig. 4-2 Color Aberration Samsung Electronics...
Page 11
(X:374=7 2+30 12, Y:220=14 2+32 6) 2 0 .3 4 m m 8 7 .1 9 m m 2 0 .3 4 m m 5 1 .9 9 m m 1 8 .8 4 m m 5 1 .9 9 m m 4-10 Samsung Electronics...
Page 12
(X:374=7 2+30 12, Y:220=14 2+32 6) 2 3 .4 5 m m 1 0 .5 1 m m 2 3 .4 5 m m 6 0 .0 1 m m 3 7 .1 6 m m 6 0 .0 1 m m Samsung Electronics 4-11...
Page 13
Data Shift Button (After PAL Adjustments are Completed, Press to transmit data to the NTSC mode) FACTORY CONV. ESCAPE F.MENU 3SPEED Operation of remote control may be affected by bright artificial light near to the TV set. 4-12 Samsung Electronics...
Page 14
9. LINE SHIFT Press to move a line up/down or left/right. 10. FACTORY DATA SELECT BUTTON Press to call the factory default values. MENU 11. H/V DIRECTION SELECT BUTTON Press to switch the cursor direction horizontally or vertically. Samsung Electronics 4-13...
Page 15
Press to move the convergence pattern left ( ) or right ( 18. CONVERGENCE DATA ZERO BUTTON Press to zero the convergence correction data. ROTATE 19. DATA SHIFT BUTTON Press to transmit data (PAL mode / NTSC mode). 4-14 Samsung Electronics...
If OSD is displayed as shown in figure below, press the key to exit. Then, redo step 3 to enter the Convergence Mode. NOTE After entering the Convergence Mode, Stand by for about five seconds before doing the adjustments. Samsung Electronics 4-15...
Page 17
Alignment and Adjustments -/-- 4. To adjust GREEN, first press the and the keys, and then press the key. -/-- 5. The key moves the cursor right, and the key moves the cursor left. 4-16 Samsung Electronics...
Page 18
Alignment and Adjustments key moves the cursor horizontally or vertically. MENU NOTE When the key is pressed once again, the cursor moves horizontally. MENU Samsung Electronics 4-17...
Page 19
After the Line Shift is cancelled by pressing the key, use the Channel and Volume keys (Up/Down) to make big adjustments. 9. After the green convergence adjustments are completed, press the key to save the data. 4-18 Samsung Electronics...
Page 20
B-Mute, and (3) the for B-select. 13. To adjust BLUE, redo steps 5 ~ 8, 12. 14. If any color is not properly adjusted when displaying the red, blue and green colors, readjust the color. Samsung Electronics 4-19...
Page 21
) key to save the data. The cursor moves to center, and then automatically moves up and NOTE to the left about five seconds later. S.STD 16. After the Convergence Adjustments are completed, press the key to exit. 4-20 Samsung Electronics...
Page 22
V POS DOWN Adjust screen left to balance PICTURE SETUP V SCALE SHRINK GROW EXIT RECALL SETTINGS EXIT SAVE AND E XI T Exit Adjust horizontal position (bottom) . Save and Exit Volume+ key CH Down,Volume+ key Samsung Electronics 4-21...
Page 23
P I CT URE SE T UP RESET EXIT EXIT Finish picture setup Finish Computer Setup Exit Volume+ key F.Menu key Adjust four different modes:VGA3 (VGA), VGA (DOS), VESA (SVGA), VEAS (XGA). 2). Perform the setup for each PC mode and picture setup. 4-22 Samsung Electronics...
Page 24
Exit Save and Exit Adjust horizontal position (bottom) CH Down, Volume+ key Volume+ key 1. Adjust four different modes:VGA3 (VGA), VGA (DOS), VESA (SVGA), VEAS (XGA). 2. Perform the setup for each PC mode and picture setup. Samsung Electronics 4-23...
A N A L O G G N D SCL1 A N A L O G V C C SDA1 H A L F T O N E VSYNC OSD B HSYNC OSD G BLANK OSD R 4-24 Samsung Electronics...
Page 26
SCART2-IDENT SCART2 IDENT INPUT PORT ANALOG GND ANALOG VCC HALF TONE SIGNAL FOR OSC-FREQUENCY OSD CONTROL OSD B ON SCREEN DISPLAY BLUE OUTPUT OSD G ON SCREEN DISPLAY GREEN OUTPUT OSD R ON SCREEN DISPLAY RED OUTPUT Samsung Electronics 4-25...
Page 27
SECAM L/L’ MAIN SECAM SYSTEM SWITCH TIMER-LED TIMER LED 4.6V CONV. MODE CONTROL DATA3 TTX-SCL TELETEXT CLOCK BUS LINE MAIN-NT-V MAIN VIDEO SAW FILTER SWITCH BUS-STOP C BUS STOP POWER2 PC POWER CONTROL 4.6V CONV. MODE CONTROL DATA2 4-26 Samsung Electronics...
Page 28
1.6V H-BLK H-BLANK INPUT VERTICAL DRIVE (+VOLTAGE) 2.6V VERTICAL DRIVE (-VOLTAGE) 2.6V ABL INPUT 2.15V V-BLK V-BLANK INPUT EAST WEST OUT 2.5V SYNC V-SYNC OUT SYNC H-SYNC OUT 5V-A 5V-B INPUT TEST-Y WHEN CG ADJ PATTERN INPUT Samsung Electronics 4-27...
Page 29
OSD-G INPUT OSD-B OSD-B INPUT BLANK(MICOM OUT) NOT USED V-MUTE VIDEO MUTE 4.72V T/P-R TTX/PIP-R T/P-G TTX/PIP-G T/P-B TTX/PIP-B T/P-F/B TTX/PIP-F/B R-OUT R-OUT G-OUT G-OUT B-OUT B-OUT IK OUT 3.65V SPOT SPOT OUT VM-Y VM-Y OUT 5.42V 4-28 Samsung Electronics...
PIP-L/L’ SECAM SYSTEM SWITCH PIP-NT-V PIP VIDEO SAW FILTER SWITCH SUB-AFT SUB-AFT OUTPUT 4.37V IF-IN IF INPUT IF-AGC V-SYNC V-SYNC INPUT H-SYNC H-SYNC INPUT FAST BLANK OUTPUT 2.46V B OUTPUT 0.66V G OUTPUT 0.66V R OUTPUT 0.66V Samsung Electronics 4-29...
Page 31
5V INPUT R-IN PC R INPUT G-IN PC G INPUT B-IN PC B INPUT PC H-SYNC INPUT PC V-SYNC INPUT SERIAL DATA LINE SERIAL CLOCK LINE INPUT REMOCON 2.5V R-OUT/Y3 PC Y3 OUT B-OUT/C3 PC C3 OUT 4-30 Samsung Electronics...
M-OUT-L MONITOR-L OUTPUT M-OUT-R MONITOR-R OUTPUT QSS-IN QUASI-SPLIT SOUND INPUT 1.95V AM-IN AM INPUT 2.53V SERIAL DATA LINE 4.6V SERIAL CLOCK LINE 4.6V 5V-A 5V-A INPUT 8V-INPUT AV4-RIN AV4-R INPUT AV4-LIN AV4-L INPUT S-RESET SOUND RESET INPUT Samsung Electronics 4-31...
Page 33
Alignment and Adjustments PIN NO. ITEM FUNCTION OUT VOLT 12V INPUT SURROUND DOLBY SURROUND OUTPUT 5.6V CENTER DOLBY CENTER OUTPUT 5.6V MAIN-R MAIN-R OUTPUT 5.6V MAIN-L MAIN-L OUTPUT 5.6V 4-32 Samsung Electronics...
Page 34
FBT DC FEED BACK 4.87V X-RAY X-RAY PROTECT F/B 2.10V HV-REG HV-REG 3.54V HV-DRIVE HIGH VOLTAGE DRIVE 0.32V H-DRIVE H-DRIVE OUT HEATER HEATER INPUT AC[0.7V] 208V 208V INPUT 208V V2 INPUT D-FOCUS DYNAMIC FOCUS OUT SCREEN SCREEN INPUT 1356V Samsung Electronics 4-33...
Page 35
V-BLK INPUT H-BLK H-BLK INPUT 0.52V COMP COMP VIDEO OUTPUT (N.C) INPUT REMOCON CTRL CTRL (N.C) D3/SEL 0.2V WHEN TEST PATTERN B OUT G(TEST) WHEN TEST PATTERN G OUT WHEN TEST PATTERN R OUT SYNC SYNC OUTPUT 4.41V 4-34 Samsung Electronics...
Page 36
1.8V/2.4V R-OUT R OUTPUT 1.8V/2.4V 5V-D 5V-D INPUT 12V INPUT F/B-IN EXT. FATS BLANK INPUT B-IN EXT. B-INPUT 0.6V G-IN EXT. G-INPUT 0.6V R-IN EXT. R-INPUT 0.6V CVBS-IN CVBS INPUT 1.1V SERAL CLOCK LINE SERIAL DATA LINE Samsung Electronics 4-35...