Insignia NS-DMIC190P Quick Setup Manual

PACKAGE CONTENTS
• Microphone
• Alkaline 9V battery
• Foam windscreen
• Pouch
• Spare rubber bands
• Quick Setup Guide
9V battery
compartment
FEATURES
• Super-cardioid polar pattern picks up more frontal sound
• Two-step high-pass filter minimizes noise
• 3.5 mm audio plug connects to recording devices
• Built-in shock mount reduces vibrations
Cold shoe mount
with locking knob
Before using your new product, please read these instructions to prevent any damage.
INSTALLING THE BATTERY
1 Slide the battery compartment lid down and lift it off.
Low-cut
filter switch 2 Match the large (-) terminal on the battery to the small terminal on the clip, then
snap the terminals firmly together.
3 Replace the battery compartment lid.
ON
OFF
Power switch
Noise reducing
suspension system
3.5 mm audio cable
1/4" mounting threads
SETTING UP YOUR MICROPHONE USING YOUR MICROPHONE
To attach your microphone to a camera: 1 Turn on your camera.
1 Loosen the locking knob, then slide your microphone's shoe mount onto your 2 To turn on your microphone:
camera.
• Slide the power switch to ON.
2 Tighten the locking knob to secure your microphone. OR
3 Connect the 3.5 mm audio cable to your camera. • To use the low-cut filter, slide the power switch to
Note: Make sure that your camera is set up to use an external microphone. See the
Note: The low-cut filter minimizes the impact of low frequency hum, camera motor noise,
instructions that came with your camera for more information. and similar low frequency ambient noise.
3 Aim the microphone at the sound source and away from unwanted sound
To attach your microphone to a tripod: sources.
1 Tighten the microphone to the 1/4" screw on a tripod or tripod plate. See the Tip: If using a tripod or a boom, the microphone could be held below or above as well as
straight in-front of the sound source.
instructions that came with your tripod for more information.
2 Connect the 3.5 mm audio cable to your camera.
Note: You can also attach the microphone to a boom or pistol grip using the 1/4" mounting
threads. See the instructions that came with your boom or pistol grip for more information.
4 Slide the power switch to OFF when you are finished recording.
Quick Setup Guide |
Shotgun Condenser Microphone
Power switch
USING YOUR WINDSCREEN
Low-cut filter switch
• To prevent noise if the microphone is moving or in wind, slide the foam
windscreen onto your microphone.
ON
OFF Note: When using the microphone in high wind, use a zeppelin windscreen (not included).
.
IMPORTANT SAFETY INFORMATION
• Please read these instructions completely before you use this equipment for the
first time. It contains everything you need to know in order to avoid damage to
yourself or property.
• Make sure that you follow all safety notes.
• Keep these instructions for use in a safe place. If you sell the equipment or pass it
on to someone else, you should also pass on these instructions for use.
Unwanted
Marking on the devices
sound source
Waste disposal and protection of the environment
Electric and electronic appliances, as well as batteries, must not be
Unwanted disposed of together with domestic waste. The user is legally obliged to
sound source
return electric and electronic appliances as well as batteries to specially
set up public collecting points or the sales outlet once they have reached
the end of their service life. Details are regulated by national law. The
symbol on the product, the instructions for use, or the packaging refers to
these provisions. The recycling of waste equipment/batteries is an
important contribution to the protection of our environment.
Sound source Sound source
NS-DMIC190P/NS-DMIC190P-C