PURPOSE OF THIS GUIDE This guide contains important information regarding the installation, safe handling and maintenance of photovoltaic modules made by Hanwha SolarOne. The word “module” as used in this guide refers to one or more PV modules. All instructions should be read and understood prior to installing the modules. The installer should conform to all the safety precautions in this guide when installing the modules.
January 1, 2012 Do not fit solar modules and wiring with wet plugs and sockets. Make sure to use proper safety equipments (insulated tools, insulated gloves, etc.) when wiring. Make sure that the connection is made when the circuit is cut off. Do not disconnect under load.
January 1, 2012 In order to achieve maximum annual yield, optimum orientation and tilt of PV module is necessary. Sunlight shining vertically and completely onto PV module is the best condition to generate maximum power. Artificially concentrated sunlight shall not be directed on the module. Very hot module(s) can reduce power output performance.
Page 5
January 1, 2012 Figure1_ Mounting System Bolt Mounting Clamp Mounting Worst Mounting Part list Clamp type: clamp , M6 Bolt Note: The Mounting Bolt and Nut must tighten the exact location (Mounting Hole) Otherwise, The Mounted Module could break during operation. Hole Position Dimension 60series...
January 1, 2012 GROUNDING Before installing your solar system, contact local authorities to determine the necessary grounding. Attach all module frames to an earth ground in accordance with the National Electrical Code (NEC 250). Model installed in Canada shall be in accordance with CSA C22.1, Safety Standard for Electrical Installations, Canadian Electrical Code, Part 1.
Location with potential extreme salt damage MAINTENANCE AND CARE Dirt on the surface of solar module may decrease the power generation. Hanwha SolarOne modules have a self-cleaning function under rainfall weather condition. Module with a mounted tilt angle more than 15°is more effective than other mounting angle.