Contents Contents Machine Overview General Safety Information Getting Started Maintenance Looking After Your Machine – Filters Looking After Your Machine – Advanced cleaning Looking After Your Machine – Removing blockages FAQs Other Information...
(Note: Post-motor fi lter is housed in the left wheel) 12. Pre-motor fi lter 13. Motorised powerhead 14. Hardfl oor tool 15. Telescopic extension tube 16. Dusting brush 17. Crevice tool 18. Flexible hose and handle 19. Upholstery tool 20. Mini turbo tool vax.com.au...
Only use as described in this manual. Only use Vax recommended attachments. Do not use the vacuum cleaner if it has been dropped, damaged, left outdoors or dropped into water. Do not use the vacuum cleaner with a damaged cord or plug.
Cleaning filters and replacing them when discoloured/damaged maintains vacuum performance and prevents damage to the vacuum cleaner. Vax recommends that they should be checked, cleaned and replaced periodically (depending on the level of use). Make sure all filters are completely dry before inserting back into the vacuum cleaner.
Getting Started Keep your Vax like new IMPORTANT: The condition of the fi lters aff ects the performance of your machine. Please check, clean and replace fi lters periodically (depending on the level of use). For full cleaning instructions, see pages 7-8.
fl oor head and tubes can be attached for storage and carrying. Packing away and storage Emptying and cleaning the dirt container Press dirt container release Press the dust release lever button and lift. to empty dirt. vax.com.au...
Looking After Your Machine - Filters Cleaning the pre-motor fi lter NOTE: Clean regularly and replace the fi lter when discoloured or damaged (frequency will depend on level of use). WARNING: Water temperature should not exceed 40°C when washing the pre-motor fi lter. WARNING: Ensure fi lter is completely dry before inserting back into the vacuum cleaner.
Page 9
NOTE: Clean regularly and replace the fi lter when discoloured or damaged (frequency will depend on level of use). WARNING: Do not wash the post-motor fi lter. WARNING: For best cleaning results fi lters require cleaning at least every three months. Do not use your vacuum cleaner without all of the fi lters in place. vax.com.au...
Looking After Your Machine - Advanced Cleaning Advanced cleaning - primary separator WARNING: Ensure separator is completely dry before inserting back into the vacuum cleaner. 24hr Advanced cleaning - cyclone separator WARNING: Always switch off and unplug the vacuum cleaner from the electrical socket before assembling, opening or emptying the dirt container, or before connecting/disconnecting the attachments.
Removing blockages from the Powerhead Open clips at either side of Lift top up to reveal brushbar. Cut away tangled hairs with the Powerhead. a pair of scissors. Be careful not to cut the bristles on the brush bar. vax.com.au...
Page 12
Looking After Your Machine - Removing Blockages Removing blockages from the Turbo tool NOTE: Switch the cleaner off and disconnect the power plug from the electrical outlet. Press the two side buttons Carefully use scissors to cut Realign turbo brush sides together &...
What do I do if the unit/an accessory becomes damaged or broken? • We’re here to help. Simply call AU 1300 361 505 / NZ 0800 800 900 or visit vax.com.au Why won’t the accessories pick up properly? •...
8.30am to 5.00pm If you have queries or concerns about using your Vax, call the Vax Careline. Calls are charged at the standard local rate. Please make a note of the serial number and model number of the vacuum cleaner before calling.