Summary of Contents for Mitsubishi Electric PAR-SL94B-E
Page 1
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Photo Descriptions Enables the use of wireless remote controller for ceiling suspended models. Applicable Models PCA-RP KA Operation indication During operation: LED (green) is lit, Emergency operation Cooler/heater button (start/stop) is provided.
Page 2
Removing the existing brand label case • Remove the brand label case (name plate with MITSUBISHI ELECTRIC) from the bottom right of the unit. If it is difficult to remove the case, use a flat-blade screwdriver, etc., taking care not to damage the panel.
Page 3
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Clips on the ceiling side Laying out the lead wire • Pass the lead wire for receiver through the retaining clips. • Fix the lead wire for receiver with the clips on the ceiling side of the unit.
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Pair Number Setting • This is the setting to specify the unit to operate with the wireless remote controller. • Make setting for J41, J42 (Jumper wire) of indoor controller board and the pair number of wireless remote cotroller.
Page 5
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Function Selection This setting is available only for Mr. Slim model. CITY MULTI model can be set by dip switch of indoor/outdoor control circuit board. Refer to technical data of CITY MULTI model to set dip switch.
Page 6
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Other function selections Now that you know how to change LOSSANY connectivity setting, there are several other settings that can be changed as well. The following table lists the various settings that can be changed through the remote controller and the default settings.
Page 7
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models Self-Check CHECK Turn on the main power to the unit. CHECK Press the button twice continuously. ON/OFF TEMP (Start this operation from the status of remote controller display turned off.) begins to light.
Page 8
Wireless Remote Controller Kit PAR-SL94B-E for Ceiling Suspended models [Output pattern B] Errors detected by unit other than indoor unit (outdoor unit, etc.) Wired remote Wireless remote controller controller Symptom Remark Beeper sounds/OPERATION INDICATOR lamp blinks Check code (Number of times)