Page 1
Installation Instructions Compactors 15" Built-In 6C61580 SS 6C61500 BB 6 061500 WW GCG1700I1" ZC6S150 SS ZCGP150I1" *For ZCGP150II and 6C61700 II, also refer to the instructions provided on the template packed with those models.
Safety information BEFORE YOU BEGIN WARNING! Read these instructions completely and Do not allow items to fall or collect behind carefully. the compactor. Failure to follow this • IMPORTANT- instruction could result in a fire. Save these instructions for local inspector's use. IMPORTANT- •...
Design information MODELS AVAILABLE GCG1580SS *For ZCGP150 II and GCG1700II, also refer GCG1500BB to the instructions provided on the template GCG1500WW packed with those models. GCG1700I1" ZCGS150SS ZCGP150I1" PRODUCT DIMENSIONS AND CLEARANCES • Allow 23" (58.4 cm) clearance atthe front for a full drawer opening, •...
ADVANCE PLANNING CLEARANCES MODELS WiTH A CUSTOM DRAWER PANEL You should be able to fully open the compactor drawer. Six inches (15.2 cm)is required on the right Models ZCGP150 II and GCG1700 II side of the compactor for bag removal. The custom drawer panel and custom handle of your •...
Installation Preparation ELECTRICAL REQUIREMENTS GROUNDING REQUIREMENTS WARNING! WARNING! FOR PERSONAL SAFETY: Remove house The improper connection of the equipment fuse or open circuit breaker before grounding conductor can result in a risk of beginning installation. Do not use an electric shock. Check with a qualified extension cord or adapter plug with electrician or service representative if you...
Installation Preparation UNPACKING THE COMPACTOR UNPACKING THE COMPACTOR (CONT.) • Move the compactor close to the installation location. • Open the compactor drawer and remove any • Use a section of the shipping carton to protectthe shipping materials or other items shipped in the finished floor.
Installation Preparation [_ LEVELING THE COMPACTOR I_ ADJUST THE RETAINING BRACKET • The top of the compactor should be at least 1/8" (3 ram) from the top of the cabinet opening. You can Determine installation depth of the compactor adjust the height of the compactor by turning the beneath the countertop, screws on the front leveling legs and rear wheels.
Installation I_ POSITION COMPACTOR UNDER I_ ATTACH THE COMPACTOR THE COUNTERTOP THE COUNTERTOP WARNING! • Use two #8-18 x 1/2" (45.7 cm x 1.3 cm) mounting screws to fasten the retaining brackets at the top When moving the compactor, use gloves to of the compactor to the underside of the countertop.
Installation [_ REINSTALL THE COMPACTOR _] INSTALLATION OF THE TRASH DRAWER BAG CADDY (on some models) • Grasp the sides of the drawer. Carefully slide the • Set the bag caddy into the drawer and hook the drawer into the compactor. pre-punched holes in the caddy on the drawer buttons.
Page 12
NOTE: P]-odtlcr ilnpvovelnent is a continuil_g Lql(](_aVOl" General Electri(. Thel-etk_re, lnatevials, _ll_pem-al_ce specifi(ations _11-( _ sul_je(r to (hmlge without nori(e. GE Consumer & Industrial Appliances General Electric Company Louisville, KY40225 Pub.No. 31-30596 ge.com 206C1559P140 08-05JR Printed in China...