Sealey VS0071 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear eye
instruction protection
manual
1. SAFeTY
WARNING! ensure Health & safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
familiarise yourself with the application and limitations of the equipment, as well as the specific potential hazards.
9
maintain the equipment in good condition
9
Keep the equipment clean for best and safest performance.
9
ensure cables and probe cannot contact moving parts.
9
DO NOT place cables and probe near high voltage items - Ht leads, spark plugs or ignition coil.
8
DO NOT allow untrained persons to operate the Vs0071.
8
DO NOT allow children to play with the Vs0071.
8
DO NOT operate the equipment when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
When not in use switch off equipment and store in a safe, dry, childproof area.
9
for prolonged storage, remove battery.
9
2. INTRODuCTION
Accurately pinpoints automotive noises and vibrations, which are converted into an electrical signal and amplified. Long pick up shaft allows use
in hard to reach places. features a volume control and supplied with headphones.
3. SPeCIFICATIONS
model no: .................................................................. Vs0071
Battery: ............................................................... 9V supplied
4. OPeRATION
4.1. remove battery compartment door on rear and connect battery.
4.2. Screw probe into head of amplifier.
4.3. Fit headphone plug into socket in the base of the amplifier and put headset on.
4.4. Switch unit on by initial movement of thumb wheel. Red LED confirms that unit is switched on.
4.5. further movement of the thumb wheel increases the headset volume; about half volume is the optimum setting for initial use.
increasing the volume may be necessary for faint sounds, but an increase in background noise will also occur.
4.6. Place the tip of the probe against the suspect part, taking care to comply with safety instructions in section 1.
4.7. the sound pitch and quality will vary, giving an indication of the location and severity of any potential problem.
WARNING! Prolonged exposure to high volumes of noise, or sudden very loud noises can result in permanent hearing loss.
‰
5. MAINTeNANCe
5.1. renew battery with a similar 9V item, refer to section 4.1.
5.2. clean with a damp cloth and a mild detergent DO NOT use solvents.
DO NOT allow unit to become wet, store in a cool, dry place.
8
© Jack sealey limited
instructions for
eLeCTRONIC STeTHOSCOPe
VS0071
model no:
Original Language Version Vs0071 | issue:2 (H, 4, l) 02/02/18