QUICK START GUIDE
SPS -48V Slimline Power Shelf
Models: J2007003L005 - alpha suffixes per Slimline Power System
Brochure
No vertical spacing is required, allow a minimum 2", inch clearance at back of shelf for rectifier airflow.
Tools required:
Wire cutters and strippers
Cable crimpers
Step 1 - Mount Shelf
1.
Reposition mounting ears as required - 3 screws each. (Reverse ears for 5" setback.) Torque to 10 in-lb.
(1.2 Nm) - Phillips screwdriver.
2. Attach shelf to the frame using a minimum of four screws (two on each side) - 12-24 (provided). Torque to 35
in-lb. (4 Nm) - 5/16" socket.
Step 2 - Connect Chassis Ground and DC Reference (CO) Ground
Lug Landings: #10 double-hole on 5/8-inch center (lugs not provided)
Some applications may rely on frame mounting screws for chassis ground, omitting the chassis ground wire.
Some applications may use the Chassis Ground strap, using a single wire for both chassis ground and DC
reference ground.
Minimum 10 AWG wire is recommended.
Torque 10-32 screws to 30 in-lb. (3.4 Nm) - 5/16" socket.
Page 1
© 2023 ABB. All rights reserved.
Torque wrench - 0-65 in-lb (0-10 Nm)
Sockets - 5/16", 7/16, etc.
SPS -48V Shelf_QSG
Screwdrivers - Philips #1 and #2,
Flat small
Rev. 2.0