● Before using this product please give your special attention to “Safety Precautions” and “Important Information” (P. EN2 - EN4). ● Please keep this Operating Instructions for future use. ● Panasonic will not accept any liability if the appliance is subject to improper use, failure to comply with these instructions. Contents Safety Precautions ............................EN2...
Page 4
There is abnormal turning noise while in use. ● There is another abnormality or failure. ● Contact Panasonic Service Centre for inspection or repair. ➜ Make sure the voltage indicated on the label of the appliance is the same as your local supply. ●...
Safety Precautions Please make sure to follow these instructions. CAUTION Do not assemble the spinner when there is food residue left around the container. ● Do not replace any parts of the appliance with non-genuine spare parts. ● Do not carry the appliance by holding the power cord, feeding tube or container. When ●...
Parts Names and Instructions ■ ■ Juicer Accessory Food Pusher Brush Feeding Tube Container Cover Spinner Pulp Container (approx.500 mL) Container Clamp (both sides) High speed Switch Knob Low speed Cup Cover 60 0 60 0 Juice Cup Power Plug* Motor Housing Power Cord Maximum Amount...
Turn the switch knob to “0” position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a normal temperature) to release overheating protection before using again. (If appliance still does not operate, contact Panasonic Service Centre for inspection or repair.) Before Use Clean all detachable parts before using the appliance for the first time or when you have not used it for a while, and then assemble them securely.
How to Use Place the container onto the motor housing. ① Place the spinner in the container and fix it into position. ● Make sure the container sits properly ② on the motor housing. Place the container cover onto the container.
After Use ● Before detaching parts, make sure the motor has stopped completely, then disconnect the plug from the outlet. ● Clean the parts thoroughly after every use. Keep all parts clean and dry always. ● Do not use benzine, thinner, bleach, alcohol, nylon face of sponge, metal brushes or polish powder etc. ●...
Troubleshooting Before calling for service, please check through this section. Problem Cause and Action ● The container/spinner/container cover/clamp(both sides) is not set properly. ➝ Assemble it tightly. (P. EN7) The appliance does ● The protection device of overload or overheating is activated. not turn on.