Page 1
NETWORK PACK STARTUP GUIDE NETZWERKPACK BEDIENUNGSLEITFADEN BACK DE RESEAU GUIDE DE DEMARRAGE GUÍA DE INICIO DEL ADAPTADOR DE RED GUIDA RAPIDA AL CORREDO DI RETE SA-DV6000 INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D’INSTRUCTIONS INSTRUCCIONES ISTRUZIONI For Customer Use: VICTOR COMPANY OF JAPAN, LIMITED Enter below the Serial No.
Page 2
9. This appliance should be operated only from the type of power source indicated on the marking label. If you are not FOLLOWING TWO CONDITIONS : (1) THIS DEVICE Changes or modifications not approved by JVC could MAY NOT CAUSE HARMFUL INTERFERENCE, sure of the type of power supplied to your home, consult your dealer or local power company.
Page 3
This equipment is in conformity with the provisions and protection requirements of the correspond- Setting of the SA-DV6000 is performed on the menu screen of the BR-DV6000 VCR. ing European Directives. This equipment is designed for professional video appliances and can be For details on the setting methods, please see the Network Pack User’s Guide (pdf) included...
Software Windows 2000 Professional, Windows XP Home Edition, Windows XP Professional ● Be sure to turn the VCR’s power supply OFF before the SA-DV6000 is attached to the VCR. (English) ● Be sure to turn the VCR’s power supply OFF before inserting or removing CF (Compact Flash) Others Streamproducer is an application applicable to Microsoft Windows Media.
What the SA-DV6000 can be used for What the SA-DV6000 can be used for (cont’d) Sending VCR video/audio by e-mail using CF (Compact Flash) card Connecting a notebook computer for remote control with monitor CAM&VTR CONTROL VTR CONTR VTR CONTROL...
(CPN) LOCAL 4 Insert the board of this product (SA- DV6000) along the guide rails, correctly align the connectors and push in. 5 Fix the SA-DV6000 onto the BR-DV6000 VIDEO COMPONENT REMOTE2 LINE main unit using the two screws 2 that...
CH-3/4 (CPN) LOCAL ● Allowable storage temperature: –20°C to 60°C 2 Insert a card into the Card Slot of this product (SA-DV6000). ● Allowable operating humidity: 30% to 80% RH ● Network interface: RJ-45 (category 5), 10 BASE-T/100 BASE-Tx Memo...
Page 9
The SA-DV6000 Network Pack is designed to enhance and complement the BR-DV6000 DV Video Cassette Recorder functionality. Basic By adding networking capabilities to the BR-DV6000, the SA-DV6000 allows users to connect to and stream video and audio from the Inserting/removing CF memory card/LAN card ..........................4 VTR in real-time, from anywhere in the world.
When turning the power on, the card status in LAN enabled 01:23:45 INS display shown on left will flash during initial- : CF memory card ization. Removing card Turn off the BR-DV6000 power. Press the EJECT button of SA-DV6000 and remove the card.
Information from Network Pack SA-DV6000 is displayed on the BR-DV6000 LCD screen. When attaching Network Pack SA-DV6000 to BR-DV6000 DV Video cassette recorder, NETWORK PACK CONFIG menu and MOVIE Card status and warnings will be displayed when setting the LCD screen to the Enlarged display mode.
Menu settings Menu settings NETWORK PACK menu screen items NETWORK PACK menu screen items indicates default factory setting. Item Setting Description ✩ indicates items that can also be set from a PC. (☞ page 54) MPEG REC TRIG Selects the operation method for recording video data to a CF memory card or sending Item Setting Description...
Setting network parameters Menu screen settings can be made regardless of whether a card is inserted. Settings will be stored in the SA-DV6000 memory even When using a LAN card or LAN terminal, network related settings for SA-DV6000 are made using NETWORK MAIN SETUP of the when turning the power off.
Menu settings Menu settings NETWORK Settings menu screen item NETWORK Settings menu screen item NETWORK SETUP menu screen indicates default factory setting. PORT SETUP menu screen indicates default factory setting. ✩ indicates items that can also be set from the Web. Item Setting Description...
Currently inputted number of characters/ NAME Set when connecting from the Web browser. max.number of characters [Default setting: jvc] Example: Changing HTTP USER NAME from jvc to jvc-1234 NAME HTTP Displays the HTTP PASSWORD input screen. (4 ~ 8 alphanumerical characters) 3 / 8...
VTR’s outputs or the video recorded to tape. Please refer to the table on Page 8 for the encoding values A CK display. NE T WOR K MA I N P . . supported by the SA-DV6000. EN CODE P . . MPE G R EC TR G MOV I E CL I P P .
DISP ( ) button MENU button Other than the use of a LAN card, the SA-DV6000 is also equipped with a LAN terminal for LAN connection. When using a LAN card, SEARCH+ ( ) button however, the LAN terminal will be disabled. Up to 10 clients can access the VTR simultaneously, all viewing the video stream. If the client is a media server or equivalent, numerous clients will be able to view streaming data via the server.
A.DUB PLAY PAUSE SEARCH– SEARCH+ A list of LAN card currently supported by the SA-DV6000 is shown on Page 4. Any compatible LAN card can be used in the Client PC. EJECT STOP SUBNET MASK 255. 255. 255. 000 HOLD...
DHCP IP ADDRESS 192. 168. 100. 101 A list of LAN card currently supported by the SA-DV6000 is shown on Page 4. Any compatible LAN card can be used in the Client PC. SUBNET MASK 255. 255. 255. 000 For Client PC settings, see the instruction manual of the LAN card or computer.
Refer to the appropriate manual for setting the PC LAN card ● If WEP data encryption is used, the same key must be used in the SA-DV6000 and the PC. The PC encryption mode must be set to ‘Open System’.
Set the same domain SA-DV6000 allows up to a maximum of 10 clients to be connected at the same time via a network for viewing streaming data. If the client is a media server or equivalent, more clients can view streaming data via the server. (The number of client connections allowed differs depending on the server.)
Using LAN card/LAN terminal Streaming and Capturing Video Recording to DV tape and Client PC Simultaneously The SA-DV6000 can send video on a pre-recorded DV tape or video from the video input of BR-DV6000. MENU button REC button PLAY button Capturing (save to disk) of video transmitted by means of streaming can be started/ended on the Client PC.
When operating Streamproducer or Streamcapture in the Trigger mode and mak- screen. menu screen menu screen ing network connection with SA-DV6000, sending of streaming video/audio data When operating Streamproducer or Streamcapture in the Trigger mode and mak- A CK will start from the LAN card or LAN terminal.
Recording on a CF card Recording on a CF card Preparing for CF card recording Recording to DV tape and CF card Simultaneously CF card recording cannot be performed when transmitting streaming data from the LAN terminal during the SPLIT mode. MENU button REC button PLAY button...
Recording on a CF card Recording on a CF card Recording to DV tape and CF card Independently Recording from a Pre-Recorded DV tape to a CF card MENU button PLAY button MENU button OPERATE MENU DISP RESET A.DUB PLAY PAUSE Mini OPERATE...
Recording on a CF card Recording on a CF card Specifying the range of a DV tape and recording to a CF memory card Deleting all clip files on a CF memory card Recording to a CF Memory Card can be made by specifying the range of video recorded on a DV cassette tape. MOVIE CLIP SETUP of the NETWORK PACK CONFIG menu screen is used to delete all clips on a CF memory card.
Movie clip Movie clip Selecting play back mode of movie clip Playing back a CF memory card NETWORK PACK CONFIG The repeat play selection determines how the movie clip files are played, either indi- When simultaneously recording the video to a DV cassette and CF memory card, recording event will be registered to the clip list of the menu screen vidually or in sequence.
To move to the oldest clip during middle of playback or pausing, press the REW value of the recorded max. bit rate appears during playback. ● The video encoded by the SA-DV6000 button of BR-DV6000 for more than 2 seconds.
Movie clip Movie clip Protecting a clip file on a CF memory card Deleting a clip file on a CF memory card Clips recorded on a CF memory card can be protected using the MOVIE CLIP screen. Clips recorded on a CF memory card can be deleted using the MOVIE CLIP screen. DISP ( ) button DISP ( ) button MENU button...
Movie clip Movie clip Playing back CF memory card clips on your PC Transferring a clip on a CF memory to a server A clip recorded on a CF memory card can be transferred to a server via FTP. Caution ●...
S Y S T EM . . REMO T E . . ● The default password for each user type is “sa-dv6k” for “jvc” users, first 4 characters of the password set for “jvc” users for “ENCODE” SET button or SEARCH+ ( ) button.
Network remote control Network remote control Controlling the BR-DV6000/SA-DV6000 via a network NETWORK SETUP page Caution Clicking NETWORK SETUP on the left of the Streamcorder screen displays the NETWORK SETUP screen for performing network related settings. ● When setting the NETWORK PACK SETUP screen (NETWORK SETUP, PORT SETUP, VTR CONTROL or ENCODE PARAM- ETERS) and the same menu screen is displayed on the LCD screen of BR-DV6000, values set in the NETWORK PACK SETUP screen will not appear instantly on menu screen of the LCD screen of BR-DV6000.
Network remote control Network remote control NETWORK SETUP page NETWORK SETUP page FTP Server Account Setup screen FTP client setup Factory Settings for transferring clips recorded on a CF memory card to a server via FTP are performed. Item Description setting User Name Input the FTP user name.
Network remote control Network remote control PORT SETUP page VTR control Clicking PORT SETUP on the left of the Streamcorder screen displays the PORT SETUP screen for performing port settings. VTR can be controlled using a network connection. VTR control icons Input Screen selection Click each button to per-...
Network remote control Network remote control ENCODE PARAMETERS ENCODE PARAMETERS Clicking ENCODE PARAMETERS on the left of the Streamcorder screen displays the ENCODE PARAMETERS indicates default factory setting. screen for performing video/audio compression settings. Item Setting Description Stream Type For Media Sets the player for stream playback.
About the Trigger Mode function (TRIG) Video and audio sent from SA-DV6000 via LAN can be played back on your PC in the Streamcapture screen or data can be saved to files. The Trigger Mode function can be used to save and transmit video/audio from SA-DV6000 to your PC by synchronizing to the button It can be used on a PC that has Streamproducer installed.
Page 37
About the Cast function (CAST) Various setting dialog boxes Property dialog box The Cast function can be used to send video/audio from SA-DV6000 to another PC. <Sending method> <Receiving sent video> Display the video to send in the video display window of the Video sent using the Cast function can be received using Win- Streamcapture screen and click the CAST-VIEW button.
Transferring clips on a CF memory card to a server TOP PAGE can be customized By connecting the LAN terminal of the SA-DV6000 to a network, clips on a CF memory card can be transferred to a server via FTP. TOP PAGE can be customized as desired.
Others Connecting Windows Media Player Connecting Quick Time Player Connect the SA-DV6000 to Windows Media Player using the network. Connect the SA-DV6000 to QuickTime Player using the network. Set STREAM TYPE in the ENCODE SETUP menu to “for WMP”. Set STREAM TYPE in the ENCODE SETUP menu to “for QT”.
Troubleshooting The network pack firmware version can be updated. When there is a system error, network error, unit malfunction, etc., SA-DV6000 displays the error on the BR-DV6000 LCD screen. For details concerning version update data, visit the JVC homepage. DISP ( ) button...
By using the PING command standard to Windows, it is possible to check whether the connection is correct and that communication Screen display Cause Remedy page can be made from the PC to SA-DV6000. <Operation related> NO CF CARD! There is no CF memory card inserted. Insert a CF memory card.
Others Others Terminology Terminology ● IP address ● Encryption mode Identification number assigned to each computer that is connected to a network. The address is used for communication between Setting for encrypting the flow of data during wireless communication. network devices. Following settings are available: None (Open System): No encryption.
Others About IP address/proxy server About IP address Global IP address and local IP address There are 2 types of IP addresses: “global IP address” and “local IP address”. Global IP address: Just as different IP addresses are needed on a network, all PCs using the Internet worldwide must use a unique IP address.
Page 44
This file has been downloaded from: www.UsersManualGuide.com User Manual and User Guide for many equipments like mobile phones, photo cameras, monther board, monitors, software, tv, dvd, and othes.. Manual users, user manuals, user guide manual, owners manual, instruction manual, manual owner, manual owner's, manual guide, manual operation, operating manual, user's manual, operating instructions, manual operators, manual operator, manual product, documentation manual, user maintenance, brochure, user reference, pdf manual Downloaded from:...