Page 21
English Introduction Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. General description (Fig. 1) Click-on precision trimmer attachment 2 Click-on shaving unit 3 Shaving unit release button...
Page 22
English Warning - To charge the battery, only use the detachable supply unit (HQ8505) provided with the appliance. - The supply unit contains a transformer. Do not cut off the supply unit to replace it with another plug, as this causes a hazardous situation. - This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities...
Page 23
- If your shaver comes with a cleaning system, always use the original Philips cleaning fluid (cartridge or bottle, depending on the type of cleaning system). - Always place the cleaning system on a stable, level and horizontal surface to prevent leakage.
Page 24
English - The supply unit transforms 100-240 volts to a safe low voltage of less than 24 volts. The display Battery charge indicator Note: If you press the on/off button during charging, the ‚unplug for use‘ symbol flashes white to remind you that you have to disconnect the appliance from the wall socket.
Page 25
English Battery low When the battery is almost empty, the battery charge indicator flashes orange. ’Unplug for use’ reminder The ‘unplug for use’ symbol flashes to remind you that you have to disconnect the appliance from the wall socket before you can switch it on. Cleaning reminder Clean the shaver after every shave for optimal performance (see 'Cleaning and maintenance').
Page 26
English While you activate the travel lock, the travel lock symbol lights up continuously. When the travel lock is activated, the travel lock symbol flashes. Deactivating the travel lock 1 Press the on/off button for 3 seconds. The travel lock symbol flashes and then lights up continuously.
Page 27
English Charging with the supply unit 1 Make sure the appliance is switched off. 2 Put the small plug in the appliance and put the supply unit in the wall socket. 3 After charging, remove the supply unit from the wall socket and pull the small plug out of the appliance.
Page 28
English 2 Move the shaving heads over your skin in circular movements to catch all hairs growing in different directions. Make sure each shaving head is fully in contact with the skin. Exert gentle pressure for a close, comfortable shave. Note: Do not press too hard, as this can cause skin irritation.
Page 29
English 5 Move the shaving heads over your skin in circular movements to catch all hairs growing in different directions. Make sure each shaving head is fully in contact with the skin. Exert gentle pressure for a close, comfortable shave. Note: Do not press too hard, this can cause skin irritation.
Page 30
English 1 Attach the attachment to the appliance ('click'). 2 Switch on the appliance. 3 Hold the trimmer attachment perpendicular to the skin and move the appliance downwards while you exert gentle pressure. 4 Clean the attachment after use. Cleaning and maintenance Cleaning the shaver under the tap Clean the shaver after every shave for optimal performance (see ‚Cleaning and maintenance‘).
Page 31
English 3 Switch off the appliance. Press the release button to open the shaving unit. 4 Rinse the hair chamber under the tap. 5 Rinse the shaving head holder under a warm tap. 6 Carefully shake off excess water and let the shaving head holder air-dry completely.
Page 32
Replace damaged shaving heads immediately. Always replace the shaving heads with original Philips shaving heads (see 'Ordering accessories'). Replacement reminder The replacement reminder indicates that the shaving heads need to be replaced.The shaving unit symbol and arrows light up when you switch off the appliance.
Page 33
English 2 Press the release button to open the shaving unit. 3 Pull the shaving head holder off the bottom part of the shaving unit. 4 Turn the retaining rings anticlockwise and remove them. Place them aside in a safe place. 5 Remove the shaving heads from the shaving head holder.
Page 34
English Note: Make sure that the projections of the shaving heads fit exactly into the recesses of the shaving head holder. 7 Place the retaining rings back onto the shaving heads and turn them clockwise to reattach the retaining ring. Each retaining ring has two recesses and two projections that fit exactly in the projections and recesses of the shaving head holder.
Page 35
Ordering accessories To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details). The following accessories and spare parts are...
Page 36
Please take your product to an official collection point or a Philips service center to have a professional remove the rechargeable battery. - Follow your country’s rules for the separate collection of electrical and electronic products and rechargeable batteries.
Page 37
6 Bend the battery tags aside with a screwdriver. 7 Remove the rechargeable batteries. Warranty and support If you need information or support, please visit www.philips.com/support or read the international warranty leaflet. Warranty restrictions The shaving heads (cutters and guards) are not covered by the terms of the international warranty because they are subject to wear.
Page 38
English Shaver Problem Possible cause Solution The appliance The appliance is Unplug the appliance and does not work still attached to the press the on/off button to when I press the wall socket. For switch on the appliance. on/off button. safety reasons, the appliance can only be used without...
English Problem Possible cause Solution Water is leaking During cleaning, This is normal and not from the bottom water may collect dangerous because all of the appliance. between the inner electronics are enclosed in body and the a sealed power unit inside outer shell of the the appliance.