Page 1
BUILT-IN COOKING HOBS KHG 601, KHG 602 models Instructions for use - Installation advice Before operating this hob, please read these instructions carefully...
Dear Customer, Thank you for purchasing a Kenwood Gas Hob. The safety precautions and recommendations in these instruc- tions are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance.
BEFORE USING FOR THE FIRST TIME • Read the instructions carefully before installing and using the appliance. • After unpacking the appliance, make sure it is not damaged. In case of doubt, do not use the appliance and contact your supplier or a qualified engineer. • Remove all packaging and do not leave the packing material (plastic bags, polyst- yrene, bands etc ) in easy reach of children as they may cause serious injury.
1 - FEATURES Fig. 1.1 Mod: KHG 601 Fig. 1.2 Mod: KHG 602 This appliance is Class 3 This appliance is Class 3 GAS BURNERS Auxiliary burner (A) 1,00 kW Semirapid burner (SR) 1,75 kW Rapid burner (R) 3,00 kW...
2 - HOW TO USE THE COOKTOP • To reduce the gas flow to minimum, GAS BURNERS rotate the knob further anti-clockwise Gas flow to the burners is adjusted by tur- to point the indicator towards the small ning the knobs (illustrated in figs. 2.1) which flame symbol. control the valves. • The maximum aperture position per- Turning the knob so that the indicator points mits rapid boiling of liquids, whereas to the symbols printed on the panel achie-...
Page 7
(1) with grill for small cookware: minimum diameter 6 cm (only for model KHG 601) (2) only for model KHG 602 Fig. 2.2 Fig. 2.3...
Page 8
AUXILIARY GRATE FOR SMALL PANS - Only for the m odel KHG 601 (fig. 2.4) This grate is to be placed on top of the (smaller) auxiliary burner when using small diameter pans, in order to prevent them Fig. 2.4 from tipping over.
3 - CLEANING AND MAINTENANCE GENERAL ADVICE • Before you begin cleaning you must ensure that the hob is switched off. • It is advisable to clean when the appliance is cold and especially when cleaning the enamelled parts. • All enamelled surfaces have to be washed with soapy water or some other non-abra- sive product with a sponge and are to be dried preferably with a soft cloth.
CONTROL KNOBS GLASS LID • The control knobs may be removed for (Optional) cleaning but care should be taken not to damage the seal. GAS TAPS • Periodic lubrication of the gas taps must be carried out by specialist personnel only.
Advice for the installer IMPORTANT • The appliance should be installed, regulated and adapted to function by a QUALIFIED INSTALLATION TECHNICIAN. • Failure to comply with this condition will render the guarantee invalid. • The appliance must be installed in compliance with the regulations in force in your country and in observation of the manufacturer’s instructions.
4 - INSTALLATION TECHNICAL INFORMATION FOR THE INSTALLER In order to install the cooker top into the kitchen fixture, a hole with the dimensions shown in fig. 4.2 has to be made, bearing in mind the fol- lowing: • within the unit, between the bottom of the cooktop and the upper surface of a shelf there must be a clearance of at least 30 mm.
Page 14
FASTENING THE INSTALLATION BRACKETS (figs. 4.4, 4.5, 4.6) • Each cooker top is provided with an installation kit including brackets and screws for fastening the top to fixture panels from 2 to 4 cm thick. • Turn the cooker top upside down and fasten the brackets “ F and R” to the appropriate socket holes, without tightening the screws “B” for the moment. •...
Page 15
VENTILATION REQUIREMENTS (UNITED KINGDOM ONLY) • The appliance should be installed in a room or space with an air supply in accordance with BS 5440:2 2000. • For rooms with a volume of less than 5 m , permanent ventilation through a free area of at least 100 cm will be required.
5 - GAS SECTION GAS SUPPLY REQUIREMENTS Important Note This appliance is supplied for use on NATURAL GAS or LPG (check the gas regulation label attached on the appliance). – Appliances supplied for use on NATURAL GAS: they are adjusted for this gas only and cannot be used on any other gas (LPG) without modification. The appliances are manufactured for conversion to LPG.
Page 17
GAS CONNECTION The installation of the gas appliance to Natural Gas or LP Gas must be carried out by a suitably qualified and registered installer. Installers shall take due account of the provisions of the relevant British Standards Code of Practice, the Gas Safety Regulations and the Building Standards (Scotland) (Consolidation) Regulations issued by the Scottish Development Department.
Page 18
GAS CONNECTION Cat: II 2H3+ The fitting (fig. 5.1) is made up of: – 1 nut “A” 1/2" G cylindrical 1/2" G cylindrical 1/2" G cylindrical (ISO 228-1) male (ISO 228-1) female (ISO 228-1) female – 1 elbow fitting “C” – gasket “F” Connection to the Gas Supply – Be careful when flexible pipes are used that they do not come into contact with moving parts.
Page 19
CONVERSION TO NATURAL GAS OR LPG REPLACING THE BURNER INJEC- TORS • Remove the pan-supports, the burner covers and the knobs; • Using a wrench substitute the injec- tors “J” (Figs. 5.3 - 5.4) with those ones suitable for the type of gas for which it is to be used.
Page 20
TABLE FOR THE CHOICE OF THE INJECTORS Natural Gas G30/G31 28-30/37 mbar 20 mbar Cat. 2H 3+ Nominal Reduced Ø injector Ø injector BURNERS Power Power [1/100 mm] [1/100 mm] [Hs - kW] [Hs - kW] Auxiliary (A) 1,00 0,40 Semirapid (SR) 1,75 0,45...
6 - ELECTRICAL SECTION IMPORTANT: The appliance must be installed by a qualified technician according with the current local regulations and in compliance with the manufacturer instruc- tions. Incorrect installation might cause harm and damage to people, animals or objects, for which the manufacturer accepts no responsibility. Connection to a good earth wiring system is absolutely essential.
Page 22
Important The wires in the mains lead on this appliance are coloured in accordance with the following code: Green and Yellow - Earth Blue – Neutral Brown – Live As the colours may not correspond with the markings identifying the terminals in your plug proceed as follows: –...
7 - GUARANTEE UK only If your appliance goes wrong within one year from the date you bought it, we will repair it (or replace it if necessary) free of charge provided: • you have not misused, neglected, or damaged it; •...