TABLE OF CONTENTS TABLE OF CONTENTS SAFETY 3 Before You Begin 3 Important Safety Instructions 5 Prepare to Install the Range PREPARE TO INSTALL RANGE 6 Installation Drawings ELECTRICAL CONNECTIONS 7 Electrical Connection Requirements 7 Connect Range Cord 8 3-Wire Connection With a Power Supply Cord 9 4-Wire Connection With a Power Supply Cord 9 3-Wire Connection: Conduit 10 4-Wire Connection: Conduit...
Remove all tape and packing materials before using the range. Dispose of all plastic bags after unpacking the range. Never allow children to play with packing materials. You can download the installation and owner’s manual at: http://www.lg.com. IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions before using your oven to prevent the risk of fire, electric shock, personal injury, or damage when using the range.
Page 4
SAFETY WARNING • Using an extension cord to connect the power is prohibited. The way to connect the power cord and plug directly is strongly recommended. • Electrical ground is required on this appliance. • You should make sure that the power cord is not pinched by the range or heavy objects. - Failure to do so can result in serious burns or electrical shock.
SAFETY PREPARE TO INSTALL THE RANGE WARNING • The information in this manual should be TOOLS NEEDED followed exactly. - A fire or electrical shock may result causing property damage, personal injury or death. Phillips Screwdriver Level WARNING Flat-blade Adjustable Wrench Tip - Over Hazard Screwdriver A child or adult can tip the range and be...
PREPARE TO INSTALL THE RANGE INSTALLATION DRAWINGS (LDE Series only) NOTE WARNING • You should use two or more people to move and SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR. install range. (Excessive Weight Hazard) - Failure to do so can result in back or other injury. •...
ELECTRICAL CONNECTIONS ELECTRICAL CONNECTION CONNECT RANGE CORD REQUIREMENTS WARNING This appliance must be installed and grounded on a • You never remove the protection cover covering the rear of lower oven. branch circuit by a qualified technician in accordance - Failure to do so can result in serious damage to power with the National Electrical code ANSI/NFPA NO.
ELECTRICAL CONNECTIONS 3-WIRE CONNECTION WITH A POWER SUPPLY CORD WARNING • The middle (neutral or ground) wire of a 3 wire power cord or a 3 wire conduit has to be connected to the middle post of the main Cord strain relief terminal block.
ELECTRICAL CONNECTIONS 4-WIRE CONNECTION WITH 3-WIRE CONNECTION: CONDUIT A POWER SUPPLY CORD Install the conduit as follows: WARNING Remove the Conduit connection plate from the rear of lower oven and rotate it as shown in Figure 5. The • Only a 4-conductor power-supply cord kit rated conduit hole (1 ”) must be used.
Page 10
ELECTRICAL CONNECTIONS 4-WIRE CONNECTION: CONDUIT 1. Follow the instructions under “Install the conduit as 4-wire connection follows” on page 9 to correctly install the strain relief. Black White Red DO NOT install the conduit without a strain relief. Terminal 2. Loosen the 2 lower left and right screws from the block terminal block.
INSTALL THE RANGE Replace the access cover on the back of the range. To replace the wire cover, insert the two tabs into the openings located below the opening and tighten the three screws. Lower Access cover range leveler Raise range Use a level to check your adjustments.