Ice And Water Dispenser Bezel Installation; Door Trim Insert - Viking FDBB5361 Installation Manual

Ice and Water Dispenser Bezel Installation

1
Install custom wood panels per product's
installation instructions.
3
Push firmly into cavity until lower screw holes
align with mounting holes on cavity.
5
Position upper mounting support over holes For a left hinge door, cut 5/8" x 2-3/4" in lower left corner.
underneath top section of bezel.
54
(if required)
2
Locate opening in door and position bezel.
Note: Graphics on bezel will be on top end, tilt slightly
forward to allow water tube clearance.
4
Install two screws in lower part of bezel
but DO NOT tighten all the way.
6
Note: Steps show panel upside down and notched for left
hinge application. Mirror dimensions for right hinge door.
Ice and Water Dispenser Bezel Installation
7
Adjust and reposition bezel
as necessary. Tighten all screws securely.
9
Align cube switch with sliding lever and firmly push
until sliding lever is flush with bezel.
Install Door Trim Insert
1
Use the roll of trim insert located in the drawer inside
the unit to apply to the door trim.
55
(if required cont.)
8
Replace spill tray in lower part of bezel.