Table of Contents
Advertisement
Available languages
Available languages
GAS COOKTOP INSTALLATION INSTRUCTIONS
Typical Under Counter Installation of an Electric Built-in Oven
All mounting
hardware must be used to
secure the built-in oven to
the cabinets. Refer to the
built-in oven installation
instructions.
Junction box
must be located
approx. 3" to the
left of the built-in
oven cutout.
208/240 Volt
grounded junction
box for built-in
oven.
Cut an opening in wood base
minimum 4" (10.2 cm) x 4" (10.2 cm)
to route armored cable to junction box.
* If no cooktop is
installed directly
over the oven
unit, 5" (12.7cm)
maximum is
allowed.
with a Cooktop Mounted Above
This cooktop may be
installed over certain
built-in electric oven
models.
CUTOUT DIMENSIONS (INCHES (CM))
OVEN
E. hEIghT
SIZE
min.
30" (76.2) 27 ¼" (69,2 cm) 28¼" (71.8) 28½" (72.4)
27" (68.6) 27 ¼" (69,2 cm) 28¼" (71.8) 24
Figure 3
Side filler panels are necessary
to isolate the unit from adjoining
cabinets. Panel height should
allow for installation of approved
cooktop models. See "Typical
Gas Cooktop Installation Over
an Electric Built-in Oven Installed
Under the Counter" on next page.
Unit will
overlap
cutout
(minimum)
edges by 1"
4 1/2" (11.4 cm)
(2.5cm)
Max.*
F. WIDTh
max.
min.
/
" (63.2) 25¼" (64.1)
7
8
4
36"
(91.4 cm) Min.
Use 3/4" (1.9 cm)
plywood, installed on
two runners, flush
with toe plate. Base
must be capable
of supporting 150
pounds (68 kg) for
27" models and 200
pounds (90 kg) for
30" models.
g. DEpTh
max.
min.
29" (73.7)
23½" (59.7)
23½" (59.7)
Advertisement
Table of Contents
