Cleaning The Water Tank; Cleaning The Coffee Spouts; Cleaning The Pre-Ground Coffee Funnel; Cleaning The Infuser - DèLonghi PrimaDonna Avant ESAM 6700 EX2 Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

Cleaning the water tank

1. Clean the water tank (A13) regularly (about
once a month) with a damp cloth and a little
mild washing up liquid.
2. After cleaning the water tank rinse it
thoroughly to remove all washing up liquid
residues.

Cleaning the coffee spouts

1. Clean the coffee spouts with a sponge or
cloth (fig. 35).
2. Check the holes in the coffee spout are not
blocked. If necessary, remove coffee deposits
with a toothpick (fig. 40).

Cleaning the pre-ground coffee funnel

Check regularly (about once a month ) that the
pre-ground coffee funnel is not blocked.
If necessary, remove coffee deposits with the
brush.

Cleaning the infuser

The infuser (A12) must be cleaned at least once
a month.
Important!
The infuser must not be extracted when the
machine is on.
1. Make sure the machine is correctly turned
off (see Turning off).
2. Open the service door (fig. 36).
3. Remove the drip tray and grounds container
(fig. 37);
4. Press the two red release buttons inwards
and at the same time pull the infuser
outwards (fig. 42).
Important!
RINSE WITH WATER ONLY
NO WASHING UP LIQUID - NO DISH WASHER
Do not use washing up liquid to clean the infuser
as it could cause damage.
5. Soak the infuser in water for about 5 minutes,
then rinse under the tap.
6. After cleaning, replace the infuser by sliding
it onto the internal support and pin at the
bottom, then push the PUSH symbol fully in
until it clicks into place.
Please note!
forcefully from the bottom and top as shown in
the figure.
7. Once inserted, make sure the
two red buttons have snapped
out.
8. Replace the drip tray and
grounds container.
9. Close the service door.

Cleaning the milk container

Clean the milk container each time you prepare
milk as described below:
1. Turn the lid of the
milk
container
clockwise
remove it.
2. Remove the milk
spout and intake
tube.
3. Remove
froth
regulator
by
pulling
outwards.
4. Wash
all
c o m p o n e n t s
thoroughly
hot water and mild
washing-up liquid.
All
components
can be washed
in a dishwasher,
placing them in
the top basket of
the dishwasher.
19
If you encounter difficulty
inserting
the
before inserting it you
must adapt it to the right
dimension by pressing it
then
the
it
the
with
infuser,

Hide quick links:

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents