ZyXEL Communications P-662HW-D Series Support Notes page 96

•
Apply to LAN Interface:
lan index [index#]
Usage: index#=1 main LAN
2 IP Alias#1
3 IP Alias#2
lan filter <incoming|outgoing> <tcpip|generic> <set1#> <set2#> <set3#>
<set4#>
Usage: You can apply at most four filter sets to LAN Interface.
lan save
(3) If you are very advanced user, you could edit filter set by the following
command:
sys filter set [set#] [rule#]
Usage: Set up a filter set index to edit a set.
set#: 1~12
rule#: 1~6
sys filter set type [typeID]
Usage: typeID: tcpip or generic.
Note: In one filter set, you should configure all the rules in one type: either
tcpip or generic.
sys filter set enable
Usage: Enable(active) the rule.
sys filter set ......(You could configure a filter rule on demand, the newest
command is available on release note)
sys filter set save
Usage: Don't forget to save the rule everytime you've configured it.
Reference Commands:
sys filter set index [set#] [rule#]
sys filter set name [set name]
sys filter set type [tcpip | generic]
sys filter set enable
sys filter set disable
sys filter set protocol [protocol #]
sys filter set sourceroute [yes|no]
sys filter set destip [address] [subnet
All contents copyright © 2006 ZyXEL Communications Corporation.
P-662HW-D Series Support Notes
Set the index of filter set rule, you must apply this
command first before you begin to configure the
filter rules
Set the name of filter set
Set the type of filter rule
Enable the rule
Disable the rule
Set the protocol ID of the rule
Set the sourceroute yes/no
Set the destination IP address and subnet mask of
95