Hotpoint SD 53 E X Operating Instructions Manual page 5

Power cable supply connection to the electrical mains:
We recommend you use a power supply cable which is long enough to allow
you to take the oven out of its recess in the event of maintenance operations
(only use HAR - H 05 - RRF quality cables fitted with a plug conforming to
the regulations in force.
The plug must be accessible at all times.
Unplug the appliance before all operations, even when replacing the
oven lamp.
Using the appliance without correct earthing is highly dangerous.
! After connecting the appliance to the flexible cable, tighten all the
screws on the terminal board.
APPLIANCE SPECIFICATIONS
width 43.5 cm
Dimensions*
height 32,4 cm
depth 41.5 cm
Volume* 59 l
width 45.5 cm
Dimensions**
height 32,4 cm
depth 41.5 cm
Volume**
62 l
voltage: 230-240V~ 50/60 Hz
Electrical
or 50 Hz (see data plate)
connections
maximum power absorbed
2250-2400 W
EU Directive no 65/2014
supplementing Directive 2010/30/EU.
EU Regulation no 66/2014
implementing Directive 2009/125/EC.
Standard EN 60350-1
Standard EN 50564
ENERGY LABEL
and
Energy consumption for Natural
ECODESIGN
convection - heating mode:
Convection mode
Declared energy consumption for
Forced convection Class - heating
mode: Multi-cooking
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EC of 12/12/06 (Low
Voltage) and subsequent
amendments;
- 2004/108/EC of 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments;
- 93/68/EEC of 22/07/93 and
subsequent amendments.
- 2002/96/EU and subsequent
amendments.
- 1275/2008 standby/off mode.
* Only for models with drawn rails.
** Only for models with wire rails.
GB
5