Onboard Headers And Connectors - ASROCK H61M-ITX/SI Installation Manual

2.8 Onboard Headers and Connectors

Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATAII Connectors
(SATA_0 (port 0): see p.2, No. 3)
(SATA_1 (port 1): see p.2, No. 4)
(SATA_2 (port 4): see p.2, No. 5)
(SATA_3 (port 5): see p.2, No. 6)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB6_7)
(see p.2 No. 7)
(9-pin USB8_9)
(see p.2 No. 8)
Consumer Infrared Module Header
(4-pin CIR1)
(see p.2 No. 9)
ASRock H61M-ITX/SI Motherboard
These four Serial ATAII
(SATAII) connectors support
SATA data cables for internal
storage devices. The current
SATAII interface allows up to
3.0 Gb/s data transfer rate.
Either end of the SATA data
cable can be connected to the
SATA / SATAII hard disk or the
SATAII connector on this
motherboard.
Besides six default USB 2.0
ports on the I/O panel, there
are two USB 2.0 headers on
this motherboard. Each
USB 2.0 header can support
two USB 2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
This header can be used to
connect the remote
1
GND
IRTX
controller receiver.
IRRX
ATX+5VSB
21