Advertisement
2. Slide the transducer into the bass wing slot as shown. Make certain that the
sensing element is in contact with the wing face and that the spring (made of
tempered beryllium copper) is in contact with the corresponding "leg" face of
the bridge.
Note: For best performance, the wing
slot opening should be .070" (1.8mm).
3. For permanent installation, use any
appropriate wood adhesive to bond the
shims to the face of the bass side wing. As
a result, the shims will be located between
the transducer's sensing element and the
bass side wing.
Note: The performance of the C-100 is
affected by the amount of contact area
between its sensing element and the wing
face of the bridge. Accordingly, the perfor-
mance may be adversely affected if the wing
face has been stylized or carved in any way.
4
Advertisement
