Table of Contents
Advertisement
Check before starting
•
Inspect the working area. Remove any objects that
could be thrown out.
•
Check the rubbers on the pole. Never use cracked or
damaged rubbers, damaged rubbers can cause damage
on the branches.
•
Check that the machine is in perfect working order.
Check that all nuts and screws are tight.
•
Only use the machine for the purpose it was intended
for.
•
Make sure that the handle and safety features are in
good working order. Never use a machine that lacks a
par
12 – English
STARTING AND STOPPING
s.
Starting and stopping
WARNING! The complete clutch cover
!
and pole m
machine is started, otherwise the clutch
can come loose and cause personal
injury.
Always move the machine away from the
refuelling area before starting. Place the
mac
shaft and the pole cannot come into
contact with any object. Make sure no
unauthorised persons are in the working
area, otherwise there is a risk of serious
personal injury. The safety distance is 15
metres.
Starting
Primer bulb: Press the air purge repeatedly until fuel
bulb. The bulb need not be completely
Choke: Set the choke control in the choke position.
WARNING! When the engine is started
!
with the choke in either the choke or
start throttle positions the cutting
attachment will start to rotate
immediately.
Hold the body of the machine on the ground using your
left hand (CAUTION! Not with your foot!). Grip the starter
handle, slowly pull out the cord with your right hand until
you feel some resistance (the starter pawls grip), now
quickly and powerfully pull the cord. Never twist the
starter cord around your hand.
fore the
e. Ensure that
Advertisement
Table of Contents
