Dell Dimension XPS H266 Service Manual page 77

Table A-5. Peripheral Configuration Submenu
Category
Parallel Port Interface
Parallel Port Type
USB Interface
Audio Interface
Primary PCI IDE Status
Secondary PCI IDE Status
Floppy Status
Serial Port 1 Status
Parallel Port Status
Categories (continued)
Function
Configures the built-in parallel port on the
system board. Set this category to Auto Con-
figured (the default) or to Disabled, or select a
specific port designation, I/O address, and IRQ
line for the port. The available port designa-
tions are LPT1, LPT2, and LPT3; available I/O
addresses are 378h, 278h, and 3BCh; and
available interrupts are IRQ7 and IRQ5.
Controls the mode used by the system's built-
in parallel port. Options for this category are:
•
Compatible — For a unidirectional device
•
Bi-directional — For a bidirectional device
•
ECP — For an ECP device
•
EPP — For an EPP device (not supported)
Determines whether the USB connectors are
Enabled (the default) or Disabled. If this cate-
gory is set to Enabled, the system dynamically
allocates an IRQ for the USB connectors
according to the PCI specification.
Determines whether the integrated audio con-
troller is Enabled (the default) or Disabled. Set
this category to Disabled to use a sound
expansion card instead of the integrated audio
controller.
Indicates whether the primary EIDE interface
is enabled or disabled.
Indicates whether the secondary EIDE inter-
face is enabled or disabled.
Indicates whether the diskette/tape drive inter-
face is enabled or disabled.
Indicates whether the serial port is enabled or
disabled; displays configuration settings if
enabled.
Indicates whether the parallel port is enabled or
disabled; displays configuration settings if
enabled.
System Setup Program A-9