Instrument Cluster Indicator Lights - Dodge 2016 JOURNEY User Manual

Hide thumbs Also See for 2016 JOURNEY:
Table of Contents

Advertisement

W H A T T O D O I N E M E R G E N C I E S

INSTRUMENT CLUSTER INDICATOR LIGHTS

– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is operated.
A tone will chime, and a EVIC message will appear if either turn signal is left on for more
than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– High Beam Indicator
Indicates that headlights are on high beam.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
– Vehicle Security Light
This light will flash rapidly for approximately 15 seconds when the vehicle security alarm
is arming. The light will flash at a slower speed continuously after the alarm is set. The
security light will also come on for about three seconds when the ignition is first turned on.
- Electronic Stability Control (ESC) OFF Indicator Light
The ESC OFF indicator will illuminate when the Electronic Stability Control (ESC) is
turned off.
– Electronic Speed Control ON Indicator
This indicator will illuminate when the electronic speed control has been activated to the
"ON" position.
– Electronic Speed Control SET Indicator
This indicator will illuminate when the cruising speed has been set.
Oil Change Due
Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Due"
message will display for 5 seconds along with a single chime to indicate the next scheduled
oil change interval. The engine oil change indicator system is duty cycle based, which means
the engine oil change interval may fluctuate dependent upon your personal driving style.
Resetting The Light After Servicing
• Without pushing the brake pedal, push the ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (Do not start the engine.)
• Fully depress the accelerator pedal, slowly, three times within 10 seconds.
• Without pushing the brake pedal, push the ENGINE START/STOP button once to
return the ignition to the OFF/LOCK position.
93

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents