Advertisement
Quick Links
Advertisement
Related Manuals for Vivotek AI-102
Summary of Contents for Vivotek AI-102
- Page 1 AI-102 IR Illuminator Installation Guide Rev. 1.1 IP Sur veillance...
-
Page 2: Specifications
Revision History: Rev. 1.0: Initial release Rev. 1.1: Changed effective IR range and power consumption. AI-102 Tube Type Infrared Illuminator Specifications Model Number AI-102 IR LED quantity 12 pcs in 2 tube housings IR light range 20 meters IR wavelength... - Page 3 Mounting & Cabling Preparing for installation: 1. Remove the IR illuminator from its package. 2. You should purchase power cords with adequate length. 3. A T20 hex wrench. Assemble the IR illuminator with the Support Bracket. Use the included hex wrench to assemble the support bracket, bearing housing, and the ball swivel on the illuminators.
- Page 4 Install the IR illuminator behind your network camera, i.e., FD8362/FD8362E. Orient its shooting angle after you slightly loosened the ball swivel screws. Secure the illuminators' shooting angle by fastening socket screws on the ball swivels. If you drilled a hole on the wall, you can pass power lines through the hollow of the illuminator bracket and then through the hole.
- Page 5 Wiring There are 5 wires with the illuminators: 3 for power connections and another 2 as control lines to the Digital outputs from a network camera. Refer to the diagram below for details. Power cords Connector Block Dark Blue: AC input Green: GND Brown: AC input Light Blue...
- Page 6 FD8362 GPIO Pinouts Blue: Ground Red: Digital Output DC 12V- DC 12V+ AC 24V_2 AC 24V_1 DI- (GND) DO+ (12V) Shown above is the network camera's General Purpose IO terminal block. Connect the IR illuminator's red and blue lines to pin7 and pin5 on the terminal block. Top View Power and IO cables pass through a waterproof connector.
- Page 7 Waterproof Connector Sealing Nut (A) Housing (B) Seals (C) Seal (D) Screw Nut (E) Hex Nut (F) Assembling Steps 1. Disassemble the components of the waterproof connector into parts (A) ~ (F) --> E --> D --> B --> A) as previously as shown above.
- Page 8 IR Configuration on Camera To configure the IR-related settings in camera firmware: 1. Open a browser management session according to your QIG (Quick Installation Guide). 2. On the main page, enter Configuration > Advanced mode > Media > Image (General settings) >...
- Page 9 This page is intentionally left in blank.
- Page 10 IP Sur veillance...