JVC GR-DVM75 Instructions Manual page 48

48
Fade/Wipe Effects
These effects let you make pro-style scene
transitions. Use them to spice up the transition
from one scene to the next. You can also vary
transitions from scene to scene.
IMPORTANT:
Some Fade/Wipe Effects cannot be used with
certain modes of Program AE with special
effects (07 pg. 46, 47). If an unusable Fade/
Wipe Effect is selected, its indicator
blinks
or
goes out.
VIDEO/DSC Switch
(CR-DVM75 only)
Power Switch
MENU Wheel
NOTES:
l
You can extend the length of a Fade or Wipe
by pressing and holding the Recording Start/
Stop Button.
l
If the power is turned off after a scene is
finished recording, the stored point is
erased, disabling the Picture Wipe/Dissolve
combination. When this happens, the
Picture Wipe/Dissolve indicator blinks. Also
note that power shuts off automatically if 5
minutes elapse in the Record-Standby mode.
l
The sound at the end of the last recorded
scene is not stored.
l
Picture Wipe/Dissolve cannot be used while
Night-Alive is being activated (w pg. 45).
FADE/WIPE SELECTION (m, m, I, LZ,
O,O, KI, l@l, 13 and E3)
Press the MENU Wheel in. The Menu Screen
appears.
Fade or Wipe works when video recording is started or
when you stop recording.
I
Set the VlDEO/DSC Switch to "VIDEO" (GR-
DVM75 only), then set the Power Switch to "9"
while pressing down the Lock Button located on the
switch. Open the LCD monitor fully or pull out the
viewfinder fully.
Rotate the MENU Wheel to select "m WIPE/
FADER", then press it.
1 Rotate the MENU Wheel to select the desired
function, then press it. Selection is complete. Press
the MENU Wheel in again.
*The WIPE/FADER Menu disappears and the effect
is reserved. The indicator representing the selected
effect appears.
Press the Recording Start/Stop Button to activate the
Fade-in/out or Wipe-in/out.
To Deactivate The Selected Effect. . .
. . . select "OFF" in step 4.
PICTURE WIPE OR DISSOLVE SELECTION
(ITZIP, QP, UP, E!P, OP,
q
P
and
•~)
Engage the Record-Standby mode.
If you select Picture wipe/Dissoive during recording. . .
. . .
press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode. . .
The Picture Wipe or Dissolve works when video
recording is started.
/
Follow steps 1 through 4 above.
. . . .
press the Recording Start/Stop Button to start
recording and press it again when one scene is
finished. The point at which the scene ended is
stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode after performing a Picture Wipe/
Dissolve . . .
. . . .
the point at which the scene ended is already
stored in memory.
If you start recording a new scene within 5 minutes of
the end of the previous recording (without having
turned the camcorder's power off), the previous scene
wipes out, revealing the new scene.