Specification; Troubleshooting - Sylvania SDVD1332 User Manual

Specification

Compatible disc: DVD/VCD/CD/MP3
Signal system: PAL/NTSC
Panel size: 13.3 inch
Picture resolution: 1280x800 (RGB)
Frequency response: 20 Hz to 20 kHz
Video output: 1 Vp-p/75 Ohm, unbalanced
Audio output: 1.4Vrms/10kOhm
Audio S/N: Better than 80 dB
Dynamic range: Better than 85 dB
USB: support USB 1.1
Laser: Semiconductor Laser, Wave Length: 650 nm/795 nm
Power source: DC 9-12V
Power consumption: 15 W
Operating temperature:0~40°C
Weight: 1.3 kg
Dimensions (W x D x H): 363x248x45 mm
Battery Type: Li Polymer
Rechargeable Battery Use
The unit utilizes long-life Li polymer battery for portable power supply. The battery has
no "Memory Effect" and thus can be recharged safely regardless of whether the battery
is fully or partially discharged. It's enough to recharge no longer than 5H each time, fully
recharged battery can last about 2 hours with earphones.
Precautions Related To Battery Recharge
The battery can be only recharged when turning power to OFF state, and keep continuous
power supply, the red light will be on, and the light will turn yellow when it's fully charged.
Using And Maintaining Rechargeable Battery
1. The normal working temperature is: 0
2. Always unplug AC/DC power supply for the unit when not in use;
3. Heat will create during playing, it's normal, while avoid long time playing and
unattended;
4. Avoid having the unit collide with any objects, and place away from all possible heat
sources or damp areas.
Caution:
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
Removal Of Waste Battery
°C ~40 °C ;
Main PCB
18
Before to discard EOL unit, please remove the waste battery by below steps:
a. Pull out the screws on the bottom cover by the screwdriver to unpack the unit.
b. Pull out the screws on the Main PCB board by the screwdriver to unpack the PCB
board and then the battery can be seen.
c. Remove the battery socket from the board.

Troubleshooting

PROBLEM
Make sure the machine is connected properly.
No sound or
Make sure all cables are securely inserted into
distorted sound
the appropriate jacks.
You can't advance through the opening credits
Can't advance and warning information that appears at the
through a movie beginning of movies because the disc is
programmed to prohibit that action.
The feature or action cannot be completed at
this time because:
1. The disc's software restricts it.
The icon
2. The disc's software doesn't support the
appears on
feature (e.g., angles)
screen
3. The feature is not available at the moment.
4. You've requested a title or chapter number
that is out of range.
The disc might be damaged. Try another disc;
Picture is distorted It is normal for some distortion to appear during
forward or reverse scan.
Some discs have sections that prohibit rapid
scanning or chapter skip;
If you try to skip through the warning information
No forward or
and credits at the beginning of a movie, you
reverse scan
won't be able to. This part of the movie is often
programmed to prohibit skipping through it.
If at any time in the future you should need to dispose of this product please
note that waste electrical products should not be disposed of with household
waste.Please recycle where facilities exist.Check with your Local Authority
or retailer for recycling advice.(Waste Electrical and Electronic equipment
Directive)
Owing to continuous improvement, no prior notice will be given regarding changes on above
feature and spec.
SOLUTION
19