Starting Operation; Maintenance And Service - Bosch GGS Professional 6 Original Instructions Manual

OBJ_BUCH-1050-001.book Page 23 Monday, November 16, 2009 6:51 PM
– Provide for good ventilation of the work-
ing place.
– It is recommended to wear a P2 filter-
class respirator.
Observe the relevant regulations in your
country for the materials to be worked.
Operation

Starting Operation

Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off
To start the power tool, firstly push the safety
switch against starting 7 toward the front and
afterwards press and hold the On/Off switch 6.
To lock the pressed On/Off switch 6, push the
lock-on button 7 further toward the front.
To switch off the power tool, release the On/Off
switch 6, or when it is locked, briefly press the
On/Off switch 6 and then release it.
Check grinding tools before using. The
grinding tool must be mounted properly
and be able to move freely. Carry out a test
run for at least one minute with no load. Do
not use damaged, out-of-centre or vibrating
grinding tools. Damaged grinding tools can
burst and cause injuries.
Working Advice
Optimum grinding results are achieved when
the grinding tool is moved uniformly back and
forth with light pressure. Pressure that is too
strong reduces the performance capability of
the machine and causes the grinding tool to
wear more quickly.
Bosch Power Tools

Maintenance and Service

Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and ventilation slots clean.
In extreme conditions, always use dust ex-
traction as far as possible. Blow out ventila-
tion slots frequently and install a residual
current device (RCD). When working metals,
conductive dust can settle in the interior of
the power tool. The total insulation of the
power tool can be impaired.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales Service and Customer As-
sistance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer service representatives can an-
swer your questions concerning possible appli-
cations and adjustment of products and acces-
sories.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: +44 (0844) 736 0109
Fax: +44 (0844) 736 0146
E-Mail: boschservicecentre@bosch.com
1 609 929 S82 | (16.11.09)
English | 23