Crest Audio Pro-LITE 2.0 / 3.0 Owner's Manual page 29

Mode continued
Bridge Mode screen
Save and Apply screen
Crossover Filters, Band-Pass Filters and Polarity
When you enter the "XOVER" Sub Menu, you are given three
options for how the band-pass filters can be set. When Set
"BP Filters Independently" is selected, the Channel A and B
high-pass and low-pass filters are individually set.
If you are using the amplifier in a stereo system where both
channels will be set the same, select "Channel B=A" and both
channels will be set at once. Setting the filters for Channel A
also sets Channel B.
If you create a crossover between channels of the amplifier,
select "X-over Freq A Lows B Highs" and crossover frequency
and filter type can be set with one set of controls. Set by
crossover screen, High-pass and Low-pass screens.
Bridge: Input A drives the amplifier in Bridge mode.
Note: Bridge mode is only available on the Pro-LITE
DSP 2.0 and 3.0 amplifiers.
Unlike the other function Sub Menus, the input mode does
not change until you select "Save and Apply" and return to the
Main Menu.
Set: BP Filters Independently screen
Set: BP Filters Channel B=A screen
Set: X-Over Freq A Lows B Highs screen
29