Honeywell HD3DH Configuration Manual page 9

WDR/DEFOG
1. WDR/DEFOG is set to OFF by default. To enable this feature, select D-WDR or
DEFOG.
2. Set D-WDR or DEFOG to AUTO or MANUAL.
• If AUTO is selected, the WDR or DEFOG level is set automatically based on the
environment.
• If MANUAL is selected, set LEVEL to LOW, MIDDLE, or HIGH.
3. Set MODE to ONLY DAY or ALL DAY.
• If ONLY DAY is selected, WDR or DEFOG is enabled during the day only.
• If ALL DAY is selected, WDR or DEFOG is enabled during daytime and
nighttime.
AGC
Auto Gain Control (AGC) enhances the picture brightness in low-light conditions, but also
increases picture noise.
Set AGC (0–20).
9