Advertisement
4. contents
b
3
5
Item
Part no
a)
b)
c)
5. opeRAtIon
fig.3
5.1.
Air supply
recommended hook-up procedure is shown in fig.3.
5.1.1. ensure Air sander trigger is in the "off" position (fig.1) before connecting to the air supply.
5.1.2. You will require an air pressure of 90psi, and an air flow according to specification.
WARnInG! ensure the air supply is clean and does not exceed 90psi while operating the tool. too high an air pressure and unclean
air will shorten the product life due to excessive wear, and may be dangerous causing damage and/or personal injury.
5.1.3. drain the air tank daily. Water in the air line will damage the tool.
5.1.4. clean the air inlet filter weekly.
5.1.5. line pressure should be increased to compensate for unusually long air hoses (over 8 metres). the minimum hose diameter should be
1/4" I.d. and fittings must have the same inside dimensions.
5.1.6. Keep the hose away from heat, oil and sharp edges. check the hose for wear, and make certain that all connections are secure.
5.2.
couplings.
Vibration may cause failure if a quick change coupling is connected directly to the air sander. to overcome this, connect a leader hose `
to the sander (sealey ref. AH2r or AH2r/38). A quick change coupling may then be used to connect the leader hose to the air line
recoil hose. see figs.3 & 4.
WARnInG! ensure that you read, understand and apply the safety instructions in section 1.
WARnInG! disconnect from the air supply before changing the belt.
5.3.
setup
5.3.1. unpack the product and check the contents, see fig.1. A set of 5 belts contains 1 of each of the following-: 40, 60, 80, 100 and 120 grit.
5.3.2. once connected to the air supply the sander is started by squeezing the trigger (2).
5.3.3. to remove and replace the sanding belt push the nose roller (3) towards the drive pulley (4) against spring pressure. the nose roller
bracket (5) will retract and lock allowing removal/fitting of the belt. When the new belt is in position release the pulley bracket by pushing
in and holding the nose roller bracket (5), then press and hold the tension bar (6) whilst releasing the pressure on the nose roller
bracket.
5.3.4. the tracking of the belt can be altered by adjusting screw 'B', the recessed socket head c'sunk screw (see fig.2). do not adjust screw
'A' unless loose; if loose tighten without clamping free running crowned pulley. the bracket is designed with an "angle set" in it, see
fig.5. tightening screw 'B' will change this angle, hence affecting belt tracking.
© Jack sealey limited
6
description
sA345 Belt sander
sanding Belt
4mm Hex Key
Original Language Version
Qty
4
1
1 set
1
1
loosen to sweep
belt angle cW or AcW
fig.1
2
A
B
fig.2
fig.4
Bayonet
Bayonet
sA354
Issue 1 - 05/11/14
7
Advertisement
