Advertisement
1. DISASSEMBLY
%&
1-1.
REMOVAL OF CABINET, MECHANISM
UNIT, AND MAIN BOARD
REMOVING
THE CABINET
PARTS (Fig. l-l-l)
1.
Spread
out the lock clamps
(C) in the arrow
direction
1.
2.
Remove
the cabinet and bottom cover by removing the four
slightly and remove the TM-1
PWB as shown in Fig. 1-1-2.
screws @ and four screws@.
2.
Remove
the screw@
at the chassis.
Remove
the front panel by removing the locks of the clamps
3.
Remove
the screw@
in the chassis,
the screw@,
and the
(A) using a screwdriver,
etc. and slightly rotating the bottom
holder in this order.
part in the direction
of the arrow.
4.
Remove
the two screws
~
and two screws
@ of the
mechanism
unit. The two screws @of the cassette
tray can
Notes:
Electrical
adjustments
for the this model
can be
be removed
easily
by pushing
the tray lock lever in the
performed
with only the cabinet
removed.
arrow direction to remove the lock as shown in the enlarge
When replacing
the bottom cover, do not tighten the
view A and by pushing
the lid opener
lever in the arrow
screws @ too much. Excess tightness
may damage
direction to remove
the lock as shown in the enlarge
view
the screws taps on the chassis,
B.
5.
Lift up the whole mechanism
unit and main board (CP-1
REMOVING
THE MECHANISM
MAIN UNIT AND THE
PWB assembly),
and as shown in Fig. 1-1-3, push the two
CP-1 PWB ASSEMBLY
(Fig. 1-1-2
and
l-l-3)
lock clamps (D) of the chassis in the arrow direction so that
~
After removing
the cabinet
parts, remove
the mechanism
unit
they can be removed
from the chassis.
and the CP-1 PWB assembly
connected
as follows.
L-
b-
M-AP21JE-l
Front Panel I
Unit
ver
@&
Fig. 1-1-1
–5-
Advertisement
