Water Outlet - Bosch WAW32560GB Instruction Manual And Installation Instructions

Positioning and connecting
en
Do not alter (shorten, cut through)
■
the water supply hose (otherwise its
strength is no longer guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
When connecting to a 21 mm = ½"
■
tap, first fit an adapter* with a sealing
washer from 21 mm = ½" to 26.4
mm = ¾".
*supplied depending on the model
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
rate is at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Connection
Connect the water supply hose to the
tap (26.4 mm = ¾") and to the
appliance (not necessary for Aqua-Stop
models as this is permanently installed):
Model: Standard
■
40
Model: Aqua-Secure
■
Model: Aqua-Stop
■
Turn on the tap carefully,
Note:
checking the leak tightness of the
connection points. The screw
connection is under mains water
pressure.

Water outlet

:
Warning
Risk of scalding!
When you are washing at high
temperatures, there is a risk of scalding
if you come into contact with hot water
(e.g. when draining hot water into a
washbasin).
Do not reach into the hot water.
Caution!
Water damage
If the drain hose slips out of the
washbasin or the connection point
during draining due to high water
pressure, any escaping water may
cause water damage.
Secure the drain hose so that it cannot
slip out.